The short answer
On an A Premium refrigerator, water leaking most often comes back to a replacement drain hose, pan or gasket that does not match the original, with a blocked defrost drain close behind. Most of what carries this name is a compact or undercounter cabinet with a static or skin condenser, a mechanical cold-control and a drain that ends over the compressor. That puts the first move in your hands rather than a technician’s: work the checks below in order and stop at the first one that explains what you are seeing.
What you are seeing
- What this fault looks like, and which observations point somewhere else.
- a sheet of ice under the crisper drawers, or water pooling in the bottom of the liner
- wet patches that appear only after a defrost rather than continuously
- water at the back of the cabinet near a supply connection
Ranked causes on this platform
- Ranked for an A Premium refrigerator, which runs a mechanical cold-control knob rather than a board with a display. No measured frequency exists for this address, so the order is platform judgement rather than a share.
- A replacement drain hose, pan or gasket that does not match the original — Why: Cabinets in this channel are often repaired before they are resold, and a drain tube or pan of the wrong length simply misses the evaporation tray.
- A blocked defrost drain — Why: This is the leak the cabinet produces by itself: melt water that cannot reach the pan backs up under the crisper and eventually runs out of the door.
- An evaporation pan that is cracked, dry-rotted or out of position — Why: Water that reaches the pan and then misses it produces a leak that appears only in warm weather, when there is most condensate to shed.
- Spillage rather than a leak — Why: It sounds trivial, and it is still worth eliminating first because a container that leaks slowly presents exactly like a drain fault.
What to check, in order
- The order follows the ranking above: most likely and cheapest first, nothing needing a meter until everything else is eliminated.
- A replacement drain hose, pan or gasket that does not match the original — Because: cabinets in this channel are often repaired before they are resold.
- A blocked defrost drain — Because: this is the leak the cabinet produces by itself: melt water that cannot reach the pan backs up under the.
- An evaporation pan that is cracked, dry-rotted or out of position — Because: water that reaches the pan and then misses it produces a leak that appears only in warm weather.
Checks you can safely do yourself
- Isolate the appliance before any panel comes off, and stop at the first step that explains the fault.
- Compare the drain tube, tray and gasket against the rating-plate model at a parts counter before condemning anything else. — Tools: a phone camera and the rating plate — Time estimate: a short check
- Find the drain hole at the base of the evaporator or the rear liner and clear it with warm water rather than with wire. — Tools: a turkey baster of warm water and towels — Time estimate: allow half an hour
- With the cabinet unplugged, pull the toe grille and check the pan is seated square under the drain outlet. — Tools: a nut driver and a torch — Time estimate: a quarter of an hour
- Stop condition: Stop there: the next step means metering live terminals or opening a sealed system.
Safety first
Safety
Unplug the appliance or switch off its breaker before removing any panel, because a capacitor can hold a charge after the power is off. Never open a sealed refrigeration circuit; refrigerant work is licensed work and a punctured line ends the life of the cabinet. A loaded cabinet is heavy and top-sided — move it with two people and empty the door first. While the cabinet is out of service, keep the food elsewhere: a refrigerator holds food safely at 40 degrees Fahrenheit or below, and a freezer at 0 degrees Fahrenheit or below.
When to call a technician
Call a technician when the drain blocks again soon after being cleared, when the leak is at a sealed connection behind a built-in cabinet, or when water is reaching an electrical component or the floor beneath the cabinet is damaged. Water near a supply cord is a reason to switch the circuit off first.
The fact bundle for this address was empty, so no warehouse figure appears. Every number on the page is a program safety constant, cited to its publisher. — Sources
General guidance- Refrigeration and Food Safety — USDA Food Safety and Inspection Service, fetched 2026-09-06
- 1910.147 — The control of hazardous energy (lockout/tagout) — Occupational Safety and Health Administration, fetched 2026-09-06
Other faults documented for this brand and appliance. — Nearest pages of the same kind
What this page does not cover
This page is generalized across every A Premium refrigerator family and model number: no family fault list, no model parts list, and no measured figure from the program warehouse. Where a family- or model-specific page exists it goes deeper, and it should be preferred over this one.
Links: - [A Premium Refrigerator: Will Not Start or No Power](/blog/a-premium-refrigerator-wont-start) - [GE Refrigerator: Ice Maker Fault](/blog/ge-refrigerator-ice-production)
Adjacent pages for what this one rules out. — Where to go next
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
