Verified
“Built-in microwave stopped heating. Magnetron was gone. Tech sourced OEM part and installed next day. Saved us from replacing the whole unit.”
Steven V.
Microwave Repair
GE washer won't spin is a known issue affecting GFW850 series. Our technicians specialize in GE-specific diagnostics and repair.
Samsung front-loader was shaking violently during spin cycles at our San Jose condo. Technician rebalanced the drum and replaced worn shock absorbers. Runs whisper-quiet now, even on the second floor.
“Built-in microwave stopped heating. Magnetron was gone. Tech sourced OEM part and installed next day. Saved us from replacing the whole unit.”
“Built-in microwave stopped heating. Magnetron was gone. Tech sourced OEM part and installed next day. Saved us from replacing the whole unit.”
“French door fridge was leaking water inside. Drain line was clogged with ice. Tech cleared it and showed me how to prevent it. Great service.”
“French door fridge was leaking water inside. Drain line was clogged with ice. Tech cleared it and showed me how to prevent it. Great service.”
“Oven wouldn't heat past 250. Igniter was weak — replaced it and calibrated the thermostat. Baked a cake that evening to test. Perfect.”
GE washer won't spin is typically caused by worn drive belt or failed lid switch. GE-specific factor: inverter board failure on front-load models — no motor drive signal. Repair costs $150-$400 with free diagnostic and 90-day warranty.
Inverter board failure on front-load models — no motor drive signal
Clutch pack wear on top-load models — gradual loss of spin engagement
Motor bearing failure producing grinding noise during spin attempt
Suspension spring breakage causing excessive drum travel and safety shutoff
Door lock/latch assembly failure on front-loaders preventing cycle start
Other GE models may also be affected. Book a free diagnostic for confirmation.
Seeing one of these codes? It likely indicates won't spin.
GE front-load washers (GFW850 series) are popular in space-constrained Bay Area homes where stackable configurations are needed. Inverter board failures in fog-belt environments trace to moisture infiltration through the ventilation slots on the rear panel. Multi-story townhomes with vibration-sensitive floors often trigger the suspension safety shutoff, leading to misdiagnosis as a mechanical failure.
Run GE diagnostic mode: close door, press Signal + Delay Start + Signal + Delay Start + Signal — codes display sequentially
For front-load inverter failure: check for E44 error — measure DC voltage at motor connector during spin attempt (should see pulsing DC)
For top-load clutch: remove cabinet, spin inner tub by hand — should resist rotation when clutch is engaged; free spinning means worn clutch
Test door lock assembly: close door firmly, listen for lock engage click and verify light indicator — no click means actuator replacement
Front-load inverter board replacement requires pulling the unit out, removing the rear panel, and swapping the board — about 45 minutes. Top-load clutch replacement is more involved: the technician removes the cabinet, disconnects the drive motor, extracts the gearcase/clutch assembly, and installs the new clutch. This repair takes 90-120 minutes. Door lock actuator swaps on front-loaders are 20-minute repairs.
| Diagnostic | Free |
| Typical repair | $150–$400 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
GE Expert
Brand-specific diagnostic tools and training
Same-Day Fix
Available in Bay Area
90-Day Warranty
Guaranteed parts and labor
Free diagnostic for won't spin issues. Same-day service in Bay Area.
Book Free DiagnosticWhirlpool top-loader stopped draining mid-cycle and flooded our Sacramento laundry room. Technician arrived in under an hour, cleared the pump filter, and tested three full cycles before leaving. Outstanding service.
LG washer displayed an OE error code every other load in Pleasanton. The drain pump had a sock stuck in the impeller. Technician cleared it out and ran diagnostics — zero errors since the repair.
Verified reviews from homeowners across San Francisco and Bay Area
“Sub-Zero 36-inch built-in with a noisy compressor. Compressor mounts were worn causing vibration. Mounts replaced and compressor serviced for $295. Fridge is quiet and cooling perfectly. Sub-Zero expertise is rare and valuable.”
Tammy B.
Refrigerator Repair
Palo Alto, CA
“Our Samsung dishwasher was leaking from the bottom. The technician found a loose hose clamp on the circulation pump. It was a simple fix for $120 — I really appreciated the honesty since they could have sold me a new pump. The dishwasher has been leak-free since. Trustworthy company.”
Yuki N.
Dishwasher Repair
San Mateo, CA
“KitchenAid built-in refrigerator was forming puddles underneath. Clogged defrost drain was sending water out the bottom instead of into the drain pan. The tech cleared the drain, added a drain heater clip to prevent recurrence, and cleaned the drain pan. $175 for a fix that eliminated a really annoying problem.”
Alicia R.
Refrigerator Repair
Palo Alto, CA
“Our LG French door refrigerator stopped cooling overnight. With a fridge full of food, we needed emergency service. The tech came same-day, diagnosed a failed compressor relay, and had it running in under an hour. He also told us about LG's compressor warranty which covered the part. Outstanding service.”
Anthony R.
Refrigerator Repair
Sunnyvale, CA
“Our 20-year-old Sub-Zero had a warm refrigerator section. The tech was clearly experienced with Sub-Zero — he diagnosed a failing evaporator fan and weak door gaskets. Replaced both, cleaned the condenser, and the unit is performing like new. $520 for a repair on a unit worth $15K+ to replace. No-brainer.”
Richard Y.
Refrigerator Repair
Cupertino, CA
“Called EasyBear on a Sunday morning when my Samsung fridge stopped cooling. A technician arrived by early afternoon, diagnosed a failed evaporator fan motor, and had it replaced within 90 minutes. Food saved, stress gone. The $265 was absolutely worth it.”
Karen L.
Refrigerator Repair
San Francisco, CA
“Whirlpool fridge compressor running non-stop. Dirty condenser coils were the culprit. Thorough cleaning for $95 service fee. Compressor now cycles normally and energy bill dropped.”
Dave K.
Refrigerator Repair
Daly City, CA
“The technician arrived within 2 hours of my call and diagnosed the issue immediately — a faulty defrost timer causing ice buildup. He had the part on his truck and fixed it in under an hour. My fridge has been running perfectly for 3 months now. Very reasonable price at $275.”
Sarah M.
Refrigerator Repair
San Francisco, CA
“GE upright freezer was running but not getting below 25°F. The evaporator fan motor was failing. Tech replaced it and also checked the defrost system which was still working fine. $210 total and the freezer is back to 0°F. Saved about $800 in frozen food that would have spoiled. Worth every penny.”
Raymond G.
Freezer Repair
San Francisco, CA
“Our chest freezer stopped freezing and we had hundreds of dollars of meat inside. Called at 8am and the tech arrived by 10:30am. Faulty thermostat was the culprit — replaced in 30 minutes. Saved all our food! Cost was $175. Can't thank them enough for the fast response.”
Amanda J.
Freezer Repair
Concord, CA
“Finding someone experienced with Sub-Zero was tough until I found this company. Our 15-year-old Sub-Zero was running constantly and not cooling. The tech cleaned the condenser, replaced the fan motor, and it's been running like new. Worth every penny of the $450 repair — a new Sub-Zero is $12,000+.”
James C.
Refrigerator Repair
Berkeley, CA
“The notorious Samsung ice maker problem struck our French door fridge. The tech was very familiar with this specific issue, performed the recommended fix including defrosting the evaporator and installing a new ice maker kit. It's been 6 weeks and still working great. $350 well spent.”
Wei Z.
Refrigerator Repair
Cupertino, CA