Want a regional phone & address? Pick your area.
Whirlpool·Washerlow severity
Whirlpool Error Code F0E1
Load in tub during clean cycle
Common Causes
- 1Items left in drum
Step-by-Step Troubleshooting
- 1
Open the lid or door and remove all items from the drum
- 2
Inspect for small items lodged under the agitator plate or door boot seal
- 3
Run the Clean Washer cycle with an affresh tablet or 1 cup white vinegar
- 4
If error persists after empty restart, unplug for 2 minutes to reset the control board
Pro Diagnostic Tip
This code triggers when the 6th Sense load detection system senses weight during a Clean Washer cycle. On Maytag MHW series, small items can slip under the impeller plate and remain undetected visually.
You Might Also Notice
- •Clean cycle stops mid-way
- •Display flashes rL alternating with F0E1
- •Machine beeps repeatedly during cleaning cycle
Parts, Cost & Difficulty
Repair Difficulty
Easy — DIY FriendlyEstimated Repair Cost
$0–$0
Parts + labor. Free diagnosis with repair.
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Remove items and restart clean cycle
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F0E1 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Whirlpool error code F0E1 mean?
Whirlpool error code F0E1 indicates: Load in tub during clean cycle. This is a low-severity issue affecting your washer.
How do I fix Whirlpool error code F0E1?
Open the lid or door and remove all items from the drum Then, Inspect for small items lodged under the agitator plate or door boot seal Then, Run the Clean Washer cycle with an affresh tablet or 1 cup white vinegar There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How do I know if my washer has error F0E1?
Besides the error code on the display, common signs include: Clean cycle stops mid-way; Display flashes rL alternating with F0E1; Machine beeps repeatedly during cleaning cycle. If you notice any of these symptoms, check your washer's display panel for error code F0E1.
How much does it cost to fix Whirlpool F0E1?
Repair costs for Whirlpool F0E1 typically range from $0 to $0 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.