Want a regional phone & address? Pick your area.
Hotpoint·Dishwasherhigh severity
Hotpoint Dishwasher Error Code C7
Wash motor not running
Common Causes
- 1Wash motor failure
- 2Motor capacitor failure
- 3Control board relay fault
The wash pump runs on 120V AC. Always disconnect power before accessing pump components.
Step-by-Step Troubleshooting
- 1
Power cycle at breaker for 2 minutes and restart a cycle
- 2
Listen for the wash pump engaging — hum without spray = jammed impeller, silence = motor failure
- 3
Test wash motor windings with multimeter — expect 5-20 ohms
- 4
Check motor capacitor if equipped — bulging top indicates failure
Pro Diagnostic Tip
C7 on Hotpoint dishwashers often results from a jammed impeller rather than motor failure. Remove the spray arm and filter to clear the sump before condemning the motor.
You Might Also Notice
- •Dishwasher fills but does not wash
- •No spray from arms
- •Humming noise from bottom of tub
Parts, Cost & Difficulty
Repair Difficulty
Professional OnlyEstimated Repair Cost
$200–$375
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
WD26X23258 wash pump and motor assemblyWD21X24900 motor capacitor
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Get Professional Help Now
Error code C7 is a high-severity issue that can cause further damage to your dishwasher if left unresolved. A licensed technician can diagnose and fix it the same day.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends May 31
Frequently Asked Questions
What does Hotpoint error code C7 mean?
Hotpoint error code C7 indicates: Wash motor not running. This is a high-severity issue affecting your dishwasher.
How do I fix Hotpoint error code C7?
Power cycle at breaker for 2 minutes and restart a cycle Then, Listen for the wash pump engaging — hum without spray = jammed impeller, silence = motor failure Then, Test wash motor windings with multimeter — expect 5-20 ohms There are 1 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my dishwasher has error C7?
Besides the error code on the display, common signs include: Dishwasher fills but does not wash; No spray from arms; Humming noise from bottom of tub. If you notice any of these symptoms, check your dishwasher's display panel for error code C7.
How much does it cost to fix Hotpoint C7?
Repair costs for Hotpoint C7 typically range from $200 to $375 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.