Want a regional phone & address? Pick your area.
Electrolux·Washermedium severity
Electrolux Error Code E20
Drain problem
Common Causes
- 1Clogged pump filter
- 2Kinked drain hose
- 3Drain pump blockage
Step-by-Step Troubleshooting
- 1
Open lower access panel and unscrew drain pump filter (have towels ready)
- 2
Remove coins, hairpins, and lint from filter and pump housing
- 3
Check drain hose for kinks — ensure standpipe height is 24-96 inches
- 4
Verify drain hose end is not pushed too far into standpipe (max 8 inches)
Pro Diagnostic Tip
Electrolux front-loaders with Perfect Steam tend to accumulate more lint in the pump filter than non-steam models — clean monthly for prevention
You Might Also Notice
- •Water remains in drum
- •Spin cycle does not start
- •Clothes sopping wet after cycle
Parts, Cost & Difficulty
Repair Difficulty
Easy — DIY FriendlyEstimated Repair Cost
$60–$200
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
137240800 — Drain pump assembly137370300 — Pump filter cap
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Clean pump filter
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code E20 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Electrolux error code E20 mean?
Electrolux error code E20 indicates: Drain problem. This is a medium-severity issue affecting your washer.
How do I fix Electrolux error code E20?
Open lower access panel and unscrew drain pump filter (have towels ready) Then, Remove coins, hairpins, and lint from filter and pump housing Then, Check drain hose for kinks — ensure standpipe height is 24-96 inches There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How do I know if my washer has error E20?
Besides the error code on the display, common signs include: Water remains in drum; Spin cycle does not start; Clothes sopping wet after cycle. If you notice any of these symptoms, check your washer's display panel for error code E20.
How much does it cost to fix Electrolux E20?
Repair costs for Electrolux E20 typically range from $60 to $200 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.