Want a regional phone & address? Pick your area.
Electrolux·Washermedium severity
Electrolux Error Code E11
Fill timeout
Common Causes
- 1Low water pressure
- 2Inlet valve failure
- 3Pressure switch fault
Step-by-Step Troubleshooting
- 1
Run water at the nearby faucet to verify adequate pressure
- 2
Test each inlet valve solenoid — should read 800-1500 ohms
- 3
Inspect pressure switch hose for kinks or water inside the tube
- 4
Check flow meter (on models equipped) for blockage
Pro Diagnostic Tip
E11 differs from E10 in that the machine started filling but did not reach the target level within the timeout — suspect a failing (weak) valve solenoid rather than a supply issue
You Might Also Notice
- •Partial fill then error
- •Cycle aborts after several minutes of filling
- •Water trickles instead of flowing
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$100–$280
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
137353500 — Water inlet valve137015300 — Pressure switch137501800 — Flow meter (if equipped)
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code E11 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Electrolux error code E11 mean?
Electrolux error code E11 indicates: Fill timeout. This is a medium-severity issue affecting your washer.
How do I fix Electrolux error code E11?
Run water at the nearby faucet to verify adequate pressure Then, Test each inlet valve solenoid — should read 800-1500 ohms Then, Inspect pressure switch hose for kinks or water inside the tube There are 1 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my washer has error E11?
Besides the error code on the display, common signs include: Partial fill then error; Cycle aborts after several minutes of filling; Water trickles instead of flowing. If you notice any of these symptoms, check your washer's display panel for error code E11.
How much does it cost to fix Electrolux E11?
Repair costs for Electrolux E11 typically range from $100 to $280 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.