The short answer
E_35 is published as a power-cycle instruction with no component meaning. One cause fits that description particularly well: a supply disturbance. A brownout, a spike, a neighbour’s motor starting or a breaker trip can leave a control in a state it cannot leave by itself, and clearing power is exactly the cure for that.
Whirlpool cooktop code as the manufacturer publishes it
Reference| Code | Meaning |
|---|---|
| E_35 | Power unit down by turning off the circuit breaker(s) for one (1) minute. |
What you observe alongside the code
- The code with the controls dead or partly responsive — What most owners see first.
- It clears after a power cycle — Which is what the published entry predicts.
- It returns after minutes, days or weeks — The interval is the information.
- It follows a storm, an outage or a breaker trip — A supply disturbance latching the control.
What triggers it, most likely first
- A supply disturbance — Second: a brownout, a spike or a neighbouring appliance can leave the control in a state it cannot leave by itself.
- A transient control fault — First, because it is the only cause consistent with a power cycle being the published remedy: something latched, and clearing power clears it.
- A connector working loose in the control assembly — Fourth: a reset restores it briefly, which is why a shrinking interval between appearances is the tell.
- A module beginning to fail — Last: the reading left when the reset stops holding at all.
Check in this order, and why
- Ask whether there was a storm, an outage or a breaker trip — A disturbance explains the code and predicts that the reset will hold.
- Do the documented power-cycle exactly once — It is the published response and it is also the test.
- Write down the date and what you were cooking — Two or three appearances make a pattern; one makes none.
- Note whether the kitchen was steamy or the supply disturbed — Both are causes you can act on.
Clearing the code, then the owner-safe checks
- Switch the cooktop off at its breaker for a full minute — Both poles. This is the manufacturer’s documented response to the code.
About 5 min
- Restore power and check every zone — Confirms the reset worked and gives you a baseline.
About 10 min
- Dry the control area and the glass edge — Removes the one cause of a repeat that you can reach.
Tools: clothAbout 10 min
- STOP HERE if the code returns immediately after the reset — A published remedy that does not hold means the fault is in hardware.
Before you open anything
Safety
Switch the cooktop off at its breaker before any panel comes off — a capacitor can hold a charge after the power is off, and a cooktop is fed from a double-pole breaker, so both poles have to be dead. The glass stays hot long after the zones are off. Never bridge or bypass a thermal cut-out or an interlock to keep cooking. While the controls are unreliable, treat the breaker as the off switch rather than the panel.
When this code is a service call
Call when the documented power cycle stops working, or when the gap between appearances shrinks from weeks to days: at that point a component is failing and the reset is only postponing it. Call immediately if a zone heats with nothing set or will not switch off at the panel, and isolate the cooktop at the breaker while you wait.
Neighbouring Whirlpool cooktop codes
Which model lines this reading applies to
This reading of E_35 applies to Whirlpool induction and radiant glass cooktops with the touch control that publishes this code, which is where the manufacturer documents it. A knob-controlled coil or gas cooktop has no display and cannot produce it, and a Whirlpool-built unit badged for another brand may pair the same characters with a different fault. Tolerance to supply disturbance differs between control generations, so an older cooktop on the same circuit may be unaffected.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
