The short answer
This display is informational. The display reports that Sabbath Mode is enabled, which sets the oven to remain on in a Bake setting until it is turned off. The relevant action is on the control, not inside the appliance.
This code and its neighbours on this appliance
Reference| Code | Meaning |
|---|---|
| 5Ab | The Sabbath Mode is enabled. Sabbath Mode sets the oven to remain on in a Bake setting until turned off. |
| 9d11 | There may be a problem with the Oven Door Latch Assembly, the Door Switch, or the associated wiring. |
| 4d52 | There may be a problem with the Oven Door Latch Assembly, the Door Switch, or the associated wiring. |
What you see alongside the code
- The range heats but ignores timers or settings — Some modes fix behaviour deliberately, which reads as the controls being broken.
- The code persists through a power cycle — A stored mode survives a reset, which distinguishes it from a transient fault.
- The display shows the code with nothing obviously wrong — That combination is the signature of an informational display rather than a fault.
- NEAR MISS - the range will not heat at all — A complete refusal to heat is a fault rather than a mode, and belongs on a different page.
The causes, likeliest first
- The mode or state was selected, often by accident — First because it is almost always the answer. Key combinations that set these states are easy to hit while cleaning the panel.
- A stored setting survived a power interruption — The control keeps the state in memory, so an outage does not clear it and a reset will not either.
- A diagnostic or service state left set — After a repair or a store demonstration the range can be left in a state nobody expects.
Check in this order, and why
- Confirm the range is otherwise behaving normally — If heating, lights and the panel all work, you are looking at a state and not a fault.
- Check the owner guide for the exit key combination — These states are exited deliberately, and the combination differs across the platform.
- Try a complete power-down — It will not clear a stored mode, and that result is itself informative.
The owner-safe procedure
- Write down exactly what the display shows — Informational displays are easily confused with fault codes, and the exact characters decide which it is.
About 3 min
- Check whether the range still heats and lights normally — Normal behaviour alongside the display confirms it is a state rather than a fault.
About 10 min
- Use the exit combination given in the owner guide — These modes are entered and left deliberately, and the key combination is documented for the model line.
About 5 min
Before you open anything
Safety
No panel needs removing for this display, and none should be - unplug the appliance or switch off its breaker first if one ever is, because a capacitor can hold a charge after the power is off. Do not leave food unattended in a range that is in a mode you have not identified, since some states hold heat on deliberately. Do not test anything with the appliance pulled half out and resting on its door. Doors are not designed to carry the weight and the glass can let go.
When this is a service call
Call when the state cannot be exited and a full power-down has not changed it. That combination points at a stored setting the control will not release, which is a service-side reset. There is no urgency: the range is not damaged and is not damaging itself. Get the cause named before agreeing to a part. On this platform several quite different faults arrive at the same display.
Neighbouring codes on this appliance
What this page does not cover
This page is generalized information about the code rather than about one appliance. It is written for 5Ab as the KitchenAid range code list documents it across the brand rather than for one family or model line. Where a family- or model-specific page exists for your unit it is the more specific answer and is linked from the code index for this appliance. The codes listed beside it in the table above are documented differently, so read the characters on your display carefully rather than working from a code that merely looks similar.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
