The short answer
On an Equator dishwasher the usual source of water on the floor is a door seal hardened, displaced or dirty, with washing-up liquid or too much detergent making suds next. It is a compact unit from a maker that specialises in small-footprint appliances, and that decides which joint gives first.
What you actually observe
- Water running down the front of the door — Water at the door line is the seal or the door alignment and nothing behind the machine.
- Water only when the machine drains — A leak confined to the drain stage is the drain hose or its connection at the waste.
- NEAR MISS: water is standing inside the base and never leaves — That is a drainage fault and the drainage page covers it.
The causes, most likely first on this brand
- A door seal hardened, displaced or dirty — The door seal runs round the tub and has to press evenly everywhere. A hardened section, one pushed out of its channel, or food debris sitting on it lets water through the moment the arms hit that spot. Ranked first on an Equator dishwasher: a compact door with a short seal run has very little tolerance for a displaced section.
- Washing-up liquid or too much detergent making suds — Hand dishwashing liquid in a dishwasher produces foam that fills the tub and pushes out past the door. Ranked second on an Equator dishwasher: a compact tub has very little air space above the water line for foam to occupy.
- A drain hose split, or loose at the waste connection — The drain hose is only under pressure while the pump runs, which is why this leak lasts a minute at a time. Ranked third on an Equator dishwasher: a compact machine squeezed into a gap puts a permanent kink in its own hose.
- An overfilling tub, from a float or a valve that will not close — A float stuck down, or an inlet valve that does not shut fully, fills the tub past the door line. Ranked fourth on an Equator dishwasher: a compact tub has the least freeboard above its normal fill line.
Check in this order, and why this order
- Run a finger round the whole door seal and look for debris or a section out of its channel — It is first because it costs nothing and it is the commonest source by a wide margin.
- Open the door mid-cycle and look for foam rather than water — Foam against the door is the answer and it costs nothing to look.
- Watch the drain hose along its length during the drain stage — A leak that appears only while water is going out is this or the pump, and nothing else.
What an owner can safely check
- Wipe the seal and its channel clean, then press any displaced section back into place — Warm soapy water on a cloth; check the door closes evenly on both sides afterwards.
Tools: clothAbout 15 min
- Run an empty rinse cycle with no detergent, then use only dishwasher detergent at the marked dose — A cup of milk in the base kills stubborn foam; run a rinse afterwards.
About 40 min
- Dry the hose, run a drain and feel along it for wet, then check the clip at the waste end — A split usually shows at a bend rather than in a straight run.
Tools: cloth, torchAbout 20 min
- STOP HERE if the next step needs a meter on live terminals or a panel off — That is where an owner check ends and a service call begins.
Before you open anything
Safety
Water and electricity share this cabinet, so switch off at the breaker before you mop under the machine, pull it out of its housing or touch any wiring. Close the supply valve before touching a water fitting. Steam inside a running machine is hot enough to scald, so open the door slowly. If water has reached a socket or run under a floor, leave the breaker off until it has been looked at.
When to call a technician
Call once the door seal, the detergent, the drain hose and the inlet are all clean and water still arrives, because what is left is the tub seal, the fill control or a connection under the base and all of them mean the machine out of its housing. Call immediately if water is reaching a socket, or if the floor or the cabinetry around the machine has started to swell.
Nearest pages of this class
What this page does not cover
This page covers the Equator dishwasher as a class, not one family or model line. Filter designs, spray-arm fitments, hose routing and part numbers all differ from build to build and are deliberately not here.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
