What this means on these models
Ice on the Coldspot HS platform depends on two things: water arriving, and a compartment cold enough to freeze it — and the second fails more often here. Whether your model fills itself or you fill it decides which half of this page applies. Slow ice is an early warning of a cold-side problem, which is why it is worth chasing rather than tolerating.
The observable signs on this platform
- No ice at all, no cycle noise — Listen over a full day before concluding — a compact module cycles rarely.
- Melt water refreezing below the maker — Left alone it freezes the container down, which owners then read as a broken ice maker.
- The bin is pushing the lever — A raised arm tells the module the bin is full and stops every cycle with nothing broken.
- Partial cubes in the bin — Hollow shells mean the mould was harvested early.
- NEAR MISS — external water rather than ice trouble — Water on the floor is a different page even when the ice maker is involved.
What it usually turns out to be, in order
- Too little cold where the mould sits — Ahead of the mechanism on this platform: the cold side is the weaker half, and it fails quietly.
- Door or lid not sealing on the freezer section — Humid air entering frosts the compartment, which compounds the airflow cause above.
- Air blocked around the mould — High here because these compartments are small enough to be blocked by a single overfilled bag, and the ice tray usually sits in the dead spot.
- Water supply restricted or shut off — It ranks here because the supply is behind the unit where nobody looks, and a partly closed valve mimics a failed maker.
What to check first, second, third
- Feel around the door for incoming air — A leaking seal adds humidity and starves the tray at the same time.
- Measure the compartment before touching the mechanism — Leave a thermometer beside the tray overnight rather than trusting the dial.
- Check whether anything sits against the air inlet — Second because it takes five minutes and a blocked vent produces slow ice with everything else in order.
- Look at whether the bin is holding the arm up — If the arm is held up by the bin, nothing downstream will ever run.
Before you open anything
Safety
Isolate the machine before your hands go anywhere near the ice maker — a module that decides to run is how fingers get hurt. Water and electricity share a small space here, so dry everything before restoring power. Thaw ice out rather than forcing it — a punctured mould turns a free fix into a parts job.
Models in the HS refrigerator family
Reference| Model number | Family key |
|---|---|
| HS-188CN(UR-BD146-DQ)-F | coldspot:refrigerator:hs |
| HS-188CN(UR-BD146-DQ)-R | coldspot:refrigerator:hs |
| HS-262CN(UR-BD202-DQ)-F | coldspot:refrigerator:hs |
| HS-772FWENDT | coldspot:refrigerator:hs |
| HS-772FWENDT-R | coldspot:refrigerator:hs |
Where the owner side ends
Water-line work behind the cabinet is straightforward until the joint weeps; a line that will not seal is a plumbing call. Call if the fill tube ices up repeatedly — that is a valve or pressure fault behind the symptom.
Nearest pages for this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
