The short answer
When a SHV dishwasher stops cleaning properly, the water is almost always the problem — either it is not reaching the soil or it is not carrying detergent when it arrives. With thirty-four codes in the table, this family spans several build generations and a wide range of ages in service — which is why wear causes rank higher here than they do on the brand-generic page.
What you observe on these models
- Food redeposited as a gritty film over the whole load — This is the filter signature: the soil went down the drain, was caught, and then went back over the dishes with the next spray.
- The cycle runs much longer than it used to and still washes badly — The control extends the cycle while it waits for water temperature. Cold or restricted fill produces exactly this pair of symptoms together.
- Cloudy interior and a sour smell with the poor washing — Soil that never left the tub. It is the same root cause as the grit, seen from the nose instead of the eye.
- NEAR MISS — water standing in the bottom at the end of the cycle — That is drainage, not washing, and it belongs to the drainage page for this family.
Causes, most likely first on the SHV family
- The filter assembly and sump screen are loaded with soil — Ranked first on this family, and it stays first whatever generation of the code you own: the fine filter is designed to be removed by hand, which is exactly why it is the part owners never touch.
- A spray arm is blocked, or the load stopped it turning — Second. Jets clog with the same soil the filter missed, and older units accumulate scale in the jets as well as debris.
- The water arriving is not hot enough, or the fill is restricted — Moved up the list on a family whose codes span several build generations: the inlet valve screen silts up and the tap under the sink stiffens with age, and both starve the fill.
- Rinse aid is empty, or the dispenser setting is too low — Ranked here, and it explains the wet half of the complaint outright.
- The heating circuit or its sensor has failed — Last, and that is the point of the order. It is the least likely of the five and the only one that needs a technician, so it is the one you reach by elimination rather than by guess.
Check in this order, and why
- Pull the filter and look through it — It twists out by hand, no tool. Hold it to a light: if the mesh is blind, rinse it under a hot tap with a soft brush and run one short cycle empty before you judge anything else.
- Spin both spray arms by hand, then check their jets — They should turn freely through a full circle with the racks in place.
- Run the kitchen tap hot, then start a cycle — Starting with hot water already at the tap removes the longest variable in the wash.
- Open the rinse-aid cup and the detergent cup — Fill the rinse aid if it is empty; note whether the detergent cup shows residue from the last cycle, which tells you the dispenser did not open or the water was cold.
- Only now judge the heating circuit — If the filter is clear, the arms turn, the rinse aid is full and hot water is arriving, and the load is still wet and dirty, the heating circuit is the remaining candidate and it is a service call.
Models in the SHV family — Some codes here are pinned to a single build and the rest are patterns covering several, so match the longest entry that fits the tag inside your door frame. The thirty-four codes fall into fourteen leading groups, and that spread is the reason this page is written for the family rather than for one machine.
Reference| Model number | Family key |
|---|---|
| SHV41DB** | bosch:dishwasher:shv |
| SHV41DB3N | bosch:dishwasher:shv |
| SHV41DB3N/01 | bosch:dishwasher:shv |
| SHV4AEB** | bosch:dishwasher:shv |
| SHV4AT5### | bosch:dishwasher:shv |
| SHV4AT5*** | bosch:dishwasher:shv |
| SHV4ATB*** | bosch:dishwasher:shv |
| SHV53CM** | bosch:dishwasher:shv |
| SHV53D7*** | bosch:dishwasher:shv |
| SHV53EM** | bosch:dishwasher:shv |
| SHV53T5### | bosch:dishwasher:shv |
| SHV53TB*** | bosch:dishwasher:shv |
| SHV53TL### | bosch:dishwasher:shv |
| SHV68T5### | bosch:dishwasher:shv |
| SHV68TL### | bosch:dishwasher:shv |
| SHV78B7*** | bosch:dishwasher:shv |
| SHV78CM** | bosch:dishwasher:shv |
| SHV78DM** | bosch:dishwasher:shv |
| SHV7ER5#UC | bosch:dishwasher:shv |
| SHV7PT5### | bosch:dishwasher:shv |
| SHV863WB** | bosch:dishwasher:shv |
| SHV863WD** | bosch:dishwasher:shv |
| SHV865WG3N | bosch:dishwasher:shv |
| SHV878WD** | bosch:dishwasher:shv |
| SHV878ZD** | bosch:dishwasher:shv |
| SHV88PW5** | bosch:dishwasher:shv |
| SHV88PZ5** | bosch:dishwasher:shv |
| SHV88PZ6** | bosch:dishwasher:shv |
| SHV89PW5** | bosch:dishwasher:shv |
| SHV89PW7** | bosch:dishwasher:shv |
| SHV8PT5### | bosch:dishwasher:shv |
| SHV9ER5#UC | bosch:dishwasher:shv |
| SHV9PCM** | bosch:dishwasher:shv |
| SHV9PT5### | bosch:dishwasher:shv |
Before you open anything
Safety
Unplug the dishwasher or switch off its breaker before you take any panel off — a capacitor can hold a charge after the power is off. Inside the sump there is usually broken glass you cannot see, so go in with a gloved hand and a light, never a bare hand.
When to call a technician
The line on this family is the toe-kick. Everything above it — filter, arms, dispenser, racks, the supply valve under the sink — is an owner job that needs no tool and no part.
Sources — The symptom-report corpus recorded in this snapshot is what put this symptom on the page for this brand and appliance.
Documented- amazon-reviews — amazon-reviews, fetched 2026-09-02
Other symptoms covered for this family
SC
Sarah Chen
Lead Appliance Repair Technician · 12 years experience
EPA 608 UniversalNASTeC Certified
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
