The short answer
Most noise complaints on the URBCD family trace to the cabinet and what it stands on rather than to a failing part. These are light units with a compressor mounted close to a thin rear panel, so a floor that flexes or a cabinet out of level turns a normal running sound into a noise the whole room hears.
What you observe
- A steady buzz or hum that was not there before — Continuous and tied to the compressor running. It points at mounting, level or contact with something rather than at a component that is about to fail.
- A whine or whirr that rises and falls — A fan, where the model has one. It changes with the door open on some builds, which is the quickest way to identify it.
- A rattle that comes and goes — Intermittent noise is nearly always contact - a line touching the shell, a tray moving, or a shelf that is not seated.
- The noise changes when you lean on the cabinet — That is the whole diagnosis in one move: the cabinet is transmitting into the floor or into what it is touching.
Causes, most likely first
- The cabinet standing out of level or on a flexing floor — First on this family. A light cabinet does not damp its own vibration the way a heavy one does, so a foot that is not carrying weight lets the whole shell move with the compressor.
- The cabinet touching a wall, a unit or a stored item — Second. On a compact unit sited in a tight space, the sides and back are close to something almost by definition, and any contact turns the shell into a sounding board.
- Compressor mounts that have settled — The rubber mounts under the compressor age and compress, and once they do the compressor transmits into the base instead of floating on it. It gives a steady hum that follows the running cycle exactly.
- The compressor itself — Last. Internal compressor noise is real but rare on this platform, and it is also the one cause here that is not repairable - it is a replacement decision rather than a repair.
Check in this order
- Note whether the noise is continuous, intermittent or only at start-up — This splits the list in three before you touch anything, and it is the single most useful thing you can establish.
- Put a level on the cabinet and check every foot is carrying weight — Second because it is free and because it is the first-ranked cause on this family.
- Look at the drip tray and the base cover at the back — Both move easily and both ring.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. Empty the cabinet before moving it to test for contact - a compact unit is light enough to walk on its corners and heavy enough to tip if it is loaded high.
Models in the URBCD family — The models this page covers, as the product spine lists them. This family spans more than one stem, and the stem is worth confirming in the table before any part is ordered.
Reference| Model number | Family key |
|---|---|
| UR-BCD570WE-ST | black-decker:refrigerator:urbcd |
| UR-BCD570WE1-ST | black-decker:refrigerator:urbcd |
When to call
The line on this family is the rear cover. Levelling, clearing, reseating and emptying are all owner work and need no tool.
Other faults on this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
