The short answer
No heat with everything else working is the clearest fault a microwave produces. It narrows to the magnetron circuit almost immediately — and that circuit sits behind a capacitor that makes owner diagnosis genuinely dangerous rather than merely inadvisable. The TM models share their door and interlock arrangement, which is why the door checks below sit near the top: on this family they are quick and they imitate this fault exactly.
What the owner observes
- A loud hum or buzz when the oven is running — The high-voltage transformer under load. On a unit that is not heating it can mean the circuit is drawing without delivering.
- Heating that comes and goes between uses — Intermittent heat usually means a component failing under thermal load rather than one that has failed outright.
- The oven runs but sounds quieter than it used to — The absence of the usual transformer note is itself evidence about where the fault is.
- NEAR MISS — Nothing happens at all when you press start — No light, no fan, no countdown: that is a no-power or door-latch fault and it belongs on the page about a microwave that will not start.
The ranking that matters here
- The magnetron or its high-voltage circuit — This is the most common cause of a cold microwave that otherwise behaves normally, and it is also the one owners must not investigate: the capacitor in that circuit can hold a dangerous charge long after the plug is out. It is first because a microwave that runs normally and produces no heat has, by elimination, lost the only part of itself that makes heat. The brand-wide page leads with power level, mode or a demo setting; here the magnetron or its high-voltage circuit takes that place, since it is confirmed from outside the case.
- A door, latch or interlock fault stopping the heating cycle — It matters beyond the repair itself — a door system that is not working correctly is also the part that keeps microwave energy inside the cabinet.
- Power level, mode or a demo setting — Checking it costs one cycle at full power with a cup of water, which is the same test that confirms the fault anyway.
- A thermal cut-out that has tripped — Microwaves carry thermal protectors that cut the heating circuit when the magnetron or the cavity gets too hot, often after a blocked vent or a long run.
What to check first, and why
- First — run the cup-of-water test and time it — Heat a cup of cold water at full power for a minute. Water that is unchanged, with the fan and turntable working normally, points straight at the high-voltage section — and that is the end of owner diagnosis.
- Second — look at and feel the door, latch and catch — Close it slowly and watch the latch engage. Any play, any grinding, any need to press the door to make the machine run means the door system is the first thing to have looked at.
- Third — confirm the power level and mode — Set full power and a plain timed cycle rather than a programme, and check the manual for a demonstration mode. A control reset after a power cut explains more cold food than any component.
- Fourth — let it stand for an hour and try again — If heating returns after a rest and fails again later, a thermal protector is opening. Check the vents are clear while you wait, because a blocked vent is often the reason.
Before you open anything
Safety
A microwave is the one kitchen appliance an owner should not open. The high-voltage capacitor inside can hold a lethal charge long after the plug is pulled, and it does not discharge on its own. Unplug the unit before doing anything at all, keep every check on the outside of the cabinet, and never defeat, tape or prop a door interlock: those switches are what stop the magnetron running with the door open.
Where the owner job ends
The line here is the cover. Settings, door inspection, vents and a supply test are yours; the transformer, capacitor, diode and magnetron are not, and not because they are difficult — because that circuit stores energy that has killed people who assumed unplugging was enough.
Other faults on this appliance
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
