What this usually is
On the Arctic Wind AGD dryer family a machine that will not start is much more often a door switch, a supply problem or a start circuit than a failed motor. The roster here is two models, AGD67 and AGD70. What the machine does when the button is pressed - nothing at all, a hum, or a click - decides which third of this page applies.
What you observe
- The machine hums but the drum does not turn — Power is reaching the motor and it cannot start. That is a start winding, a capacitor or a seized drum, and the hum is the diagnosis.
- A single click and then silence — A relay or a start device operating and dropping out. Usually thermal protection or a motor that will not come up to speed.
- The control panel lights but nothing runs — The control has power and something downstream is stopping the cycle. The door switch is the classic culprit here.
- NEAR MISS - it starts and then stops part way through — A cycle that will not complete is its own fault path with its own page for this family.
What it usually turns out to be
- Door switch or door catch — The tell is a machine that starts if the door is pressed firmly, or one that stopped working immediately after the door was slammed or the catch was adjusted. Across the AGD listings this is one finding rather than several.
- Supply, breaker or outlet fault — Ranked high because it is free, because it is missed constantly, and because a worn heavy-appliance outlet is a real and common finding on a machine that has been in place for years. Nothing in the AGD model spine separates its listings on this point.
- Belt broken or drum seized — Ranked here because the sound tells you immediately: free-running motor means belt, hum means load. Applies to every AGD listing in the table; the part that fits does not.
- Motor or start capacitor failed — This is the expensive answer on the page, which is exactly why it is worth having named rather than guessed.
- Body: Ordered by finding frequency. The supply sits high because it costs nothing to check and because a dryer on a double breaker can lose half its supply and still appear to have power at the control.
What to check first
- Press start and listen carefully — Silence, a hum and a click are three different diagnoses, and telling them apart is free.
- Open and close the door firmly, then try again — A machine that starts on a firm close has a marginal door switch, which is cheap and getting worse.
- Turn the drum by hand with the power off — A drum that turns freely rules out a seizure; one that will not move explains a hum immediately.
- Body: The order below starts with what the machine does when start is pressed, because on the AGD roster that single observation removes most of the ranking above before anything is opened.
Before you open anything
Safety
Isolate the machine before any panel comes off - unplug it or switch off its breaker - and remember a capacitor can hold a charge after the power is off. If the breaker trips the instant start is pressed, leave it off and call rather than resetting it repeatedly: repeated resets onto a short are how a fault becomes a fire.
Models in the AGD family — The roster this page covers, taken from the model spine. The roster carries more than one number series, so confirm the access notes below against the number on your own rating plate before you buy a part.
Reference| Model number | Family key |
|---|---|
| AGD67 | arctic-wind:dryer:agd |
| AGD70 | arctic-wind:dryer:agd |
Where the owner line is
Call once the door, the breaker, the cord and the control reset have all been tried and the machine is still dead. On the AGD roster the next step needs the cabinet open and a meter in hand. Call immediately if the breaker trips when start is pressed.
Other pages for this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
