1d11 in brief
1d11 means there may be a problem with the oven temperature sensor, the control that reads it, or the wiring between them. The sensor is the thin probe inside the oven that tells the control how hot it is; without a believable reading the control stops heating or heats unreliably, so reset once and book a test if the code returns.
Error codes
Reference| Code | Meaning |
|---|---|
| 1d11 | There may be a problem with the Oven Temperature Sensor, the Control, or the associated wiring. |
Signs that go with the code
- The oven will not preheat — The control waits for a temperature reading it does not trust.
- The oven runs much hotter than set — A sensor reading low makes the control keep heating.
- NEAR MISS: the oven is slightly off its setting, with no code — A small, steady difference is a calibration matter that the use-and-care guide covers.
Causes, most likely first
- Temperature sensor failed — Most likely: the probe’s resistance drifts out of range or opens with age and heat, and the control stops trusting it.
- Control misreading the sensor — Second: the control, which can misread a healthy sensor.
- Sensor connector or wiring — Then: the connector behind the back wall of the cavity browns and loosens in the heat, giving an on-off reading.
- Probe bent or touching the oven wall — Last: a displaced probe, which an owner can see without tools.
The order to check, and why
- Look at the probe inside the oven — With the oven cool, it should stand clear of the wall, not bent against it.
- Power-down reset — Breaker off for a minute, then try a plain bake.
- Check with an oven thermometer — A thermometer on the middle rack shows whether the oven runs hot or cold.
- Note when the code appears — At power-up, during preheat or partway through a bake.
Owner steps, with tools and time
- Power-down reset — Switch off the breaker for a minute, then restore power.
About 2 min
- Inspect the probe — With the oven off and cool, look at the probe at the back of the cavity and move racks so they do not touch it.
Tools: flashlightAbout 3 min
- Thermometer check — Place an oven thermometer on the middle rack, preheat, and compare its reading with the setting.
Tools: oven thermometerAbout 25 min
- STOP before removing the sensor or the back panel — The sensor connector sits behind the cavity wall; disconnecting and testing it is technician work.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. A wall oven is heavy and hangs on its trim and screws; taking it out of the cabinet is a two-person job, not an owner check.
When this is a service call
Call when the code returns after a reset, when the oven runs far hotter than set, or when it will not preheat. A technician measures the sensor’s resistance and checks its connector and the control’s reading before replacing anything.
Neighbouring codes
Scope of this reading
The reading above covers Amana ranges and wall ovens whose electronic control reports codes in this form. It does not cover Amana models with knob-only controls, Amana cooktops sold as separate units, which keep their own list, or sister brands on the same platform, whose lists can read differently. A model-specific page for 1d11, where one exists, is the more specific answer; none exists yet, so check the use-and-care guide for your exact model before ordering any part.
Browse the code list
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
