F9E2 in brief
The brand lists the potential cause of F9E2 as a drain motor error: the drain pump motor that empties the tub did not run as the control expected. Water may be left in the bottom; clean the filter, check for debris and kinks in the drain hose, then reset, and book a technician if the pump hums without draining or the code returns.
Error codes
Reference| Code | Meaning |
|---|---|
| F9E2 | Potential Cause: Drain motor error |
Signs that go with the code
- Water left in the bottom after the cycle — The tub never emptied.
- A hum from below with no draining — The motor is powered but cannot turn.
- No sound when it should be draining — The motor is not starting.
- NEAR MISS: the tub drains slowly but does drain — A clogged hose, air gap or disposal connection slows draining without a motor fault.
Causes, most likely first
- Drain pump blocked by debris — The most common cause: glass, seeds or labels lodge in the drain pump and stall it.
- Drain pump motor failed — Second: a worn or seized drain motor.
- Wiring or connector — Third: the connector under the tub loosens or corrodes.
- Control board — Last: the control, after the pump tests good.
The order to check, and why
- Bail out the standing water — Clears the view of the filter and the sump.
- Clean the filter and check the sump — Debris there is the most common cause.
- Check the drain hose under the sink — A kink or a crushed section blocks draining.
- Run the garbage disposal — A clogged or newly fitted disposal can block the drain inlet.
Owner steps, with tools and time
- Bail out water — Remove standing water from the tub with a cup and a towel.
Tools: cup, towelsAbout 10 min
- Clean the filter — Lift out the filter, rinse it and refit it until it locks.
Tools: soft brushAbout 10 min
- Check the hose and disposal — Look for kinks in the drain hose under the sink and run the disposal for a moment.
Tools: flashlightAbout 5 min
- STOP before removing the drain pump — It sits under the tub beside live wiring and water; replacing it is technician work.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. Never bypass the door switch or the float switch: they stop the pump and heater from running in unsafe conditions.
When this is a service call
Call when the tub will not drain after the filter, hose and disposal are clear, when the pump hums without draining, or when the code returns. Replacing the drain pump means working under the tub with the power and water off.
Other Amana dishwasher codes close to this one
Which models this reading covers
Generalized information for Amana dishwashers with an electronic control that reports codes in this form. It is not a reading for Amana dishwashers with dial-only controls, which flash lights rather than codes, or sister brands on the same platform, whose lists can read differently. The details that change inside the line, such as wiring colours, part numbers and connector locations, belong on model pages, and none is published for F9E2 yet.
All Amana dishwasher codes
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
