Before you open anything
Almison dishwashers fail in the ordinary places dishwashers fail: the drain path first, the door and its seal second, heating and washing performance after that. Very little of it is exotic and most of it is serviceable with common parts. The one class worth acting on immediately rather than living with is anything electrical, because a wet appliance with a fault has a shorter tolerance than a dry one.
What the machine is doing
- Water left standing in the bottom — The single most common presentation. Read the will-not-drain page, which works the drain path from the filter outward.
- Plates coming out dirty, gritty or filmed — A washing-performance question, and usually spray arms and filters rather than anything that has broken.
- A cycle that stops partway or never ends — The machine is failing a fill, drain or temperature check. The cycle-fault page reads the stopping point as evidence.
- Water on the kitchen floor — Door seal, door face or a hose. The water-leak page separates them by where the water lands.
- Noise that is new — Almost always something hard in the sump; the noise page starts there because that is where it usually ends too.
- A dark panel or a flashing pattern — The control page treats the panel as a messenger rather than as the fault, which is right far more often than not.
What is behind it, in order
- Drainage and filtration — First by frequency on this class of machine, because the filter is a basket and everything the basket misses settles in the sump.
- Door, latch and seal — Second. Gaskets take a set, hinges wear, and the two together produce most of the leaks.
- Washing and drying performance — Third, and mostly maintenance rather than failure: blocked jets, tired consumables and loading habits.
- Heating — Fourth. When it goes it goes cleanly, and the long cycle time gives it away before the greasy plates do.
- Controls and electrical — Last by frequency, first by urgency when it is genuinely electrical rather than a reported condition.
Problem classes at a glance
General guidance| Problem class | Frequency rank | Typical owner outcome |
|---|---|---|
| Drainage and filters | first | usually fixable without tools |
| Door and seal | second | gasket work, sometimes parts |
| Wash and dry results | third | maintenance, not repair |
| Heating | fourth | parts and a technician |
| Controls and electrical | fifth | technician, sometimes an electrician |
Based on: Ordering is technician-side for this appliance class; no counted sample exists for this badge.
When to stop and book someone
Two of the five classes are mostly owner work: drainage and washing performance both respond to cleaning that needs patience rather than skill. The door is a middle case, where cleaning and reseating a gasket is yours and hinge or spring work is not. Heating and anything electrical are service calls from the start, and an electrical symptom means switching off at the breaker rather than finishing the load. Unplug the appliance or switch off its breaker before removing any panel, whoever does the work — a capacitor can hold a charge after the power is off.
Nearest pages of this class
Scope of this page
This page is generalized across every Almison dishwasher and it is deliberately family-agnostic. It carries no model numbers, no programme charts and no part references, because those differ between builds sold under this badge, and a page that guessed at them would be confidently wrong. Where a family- or model-specific page exists for your unit it is linked from the symptom pages above and it is the more precise answer. The installation itself — the waste connection, the supply tap and the cabinet fitting — belongs to the plumbing and joinery rather than to the appliance.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
