The short answer
A-Premium is a replacement-parts label rather than a refrigerator manufacturer, so the appliance in your kitchen carries another maker’s badge and, somewhere inside it, an A-Premium part. That matters for a noise complaint, because the useful question is what changed: a newly fitted fan, mount or relay can sound different from the original without being faulty, while a part fitted slightly out of position genuinely rattles. Establish whether the noise started with the repair.
Causes, ranked for this A Premium refrigerator
- Something not refitted to its original position — Why: Most post-repair noise is a panel, tray or clip left proud rather than the new component itself, and it is found by pressing lightly on the back of the cabinet.
- A replacement fan or motor with a different sound signature — Why: An aftermarket part can be mechanically correct and still sound different from the original, which is a change rather than a fault.
- Cabinet moved during the repair and now touching or unlevel — Why: Pulling the appliance out and pushing it back changes level and clearance, so contact with a wall or cabinet turns ordinary vibration into a complaint.
- Evaporator fan striking frost — Why: This is a genuine fault and it is unrelated to the part fitted, but it is worth ruling in because the door test identifies it in one observation.
- A part that is not correct for the appliance — Why: Last, and worth naming plainly: a replacement whose specification differs from the original can run at a different speed and sound wrong for that reason.
What to check, in order
- establish whether the noise began with a repair or predates it. — Because: that single question separates a parts problem from an appliance fault.
- open the door while the sound is happening and note whether it stops. — Because: the door switch cuts the evaporator fan, isolating a genuine fault.
- check level and clearance, since the cabinet was probably moved. — Because: contact after a repair is the commonest new noise and it is free to correct.
- press lightly on the rear panel and any cover disturbed during the work. — Because: a rattle that changes under pressure is a loose fixing rather than a bad part.
Checks you can safely do yourself
- Write down when the noise started and whether it followed a repair, a part change or a house move. — Tools: none — Time: several minutes
- With the noise happening, open the door and note whether it stops immediately. — Tools: none — Time: a minute
- Check the cabinet is level in both directions and that nothing touches a wall, cabinet or neighbouring appliance. — Tools: a spirit level — Time: several minutes
- Switch off at the breaker and press gently on the rear panel, drip tray and any cover removed during the repair. — Tools: none — Time: several minutes
- Find the part number on any component recently fitted and check it against the appliance model. Stop here: refitting a component is service work. — Tools: a torch and a phone camera — Time: several minutes
Before you open anything
Safety
unplug-before-service fridge-40f
Kill power at the breaker before reaching behind the cabinet or touching any component fitted during a repair, and never chip ice off an evaporator with a metal tool. If a part was fitted by someone else, do not disturb its wiring — an incorrect connection is a hazard rather than a noise problem.
Where the owner fix ends
Checking level, clearance and loose covers is owner work. Call a technician when the noise stops as the door opens, since that is ice at the evaporator fan; when a recently fitted part is suspected of being wrong for the appliance; and when a hum grows while the compartment warms.
Nearest pages of the same kind
Generalized information — what this page does not cover
family model
This page is generalized information about refrigerators fitted with A-Premium replacement parts rather than about a refrigerator brand, and it does not separate the appliance makers, formats or fan arrangements involved. No family-level or model-level page exists in this reference yet; when one is published it will be linked here.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
