Verified
“Mike fixed the squeaking noise in my Kenmore dryer — worn drum rollers. The repair itself was good, but the scheduling was a little tricky. Had to wait 3 days for the appointment.”
Tammy C.
Dryer Repair
Kenmore dryer not heating is a known issue affecting 110 series (Whirlpool). Our technicians specialize in Kenmore-specific diagnostics and repair.
LG dryer was taking three cycles to dry a single load in Walnut Creek. Turned out the vent was 80% blocked with lint — technician cleared the full run and replaced the moisture sensor. Dries in one cycle now.
“Mike fixed the squeaking noise in my Kenmore dryer — worn drum rollers. The repair itself was good, but the scheduling was a little tricky. Had to wait 3 days for the appointment.”
“Our 12-year-old Kenmore upright freezer was building up thick frost and not staying cold enough. Defrost heater was burned out. The tech identified the actual manufacturer (Whirlpool) from the model…”
“Kenmore Elite refrigerator wasn't cooling. The tech figured out it was an LG-made unit from the model number and diagnosed a compressor issue. He was able to get it covered under LG's extended…”
“Kenmore dryer drum wasn't spinning — you could hear the motor running but nothing happening. Broken drive belt, which the tech said is one of the most common dryer repairs. Fixed in 30 minutes for…”
“Our Kenmore side-by-side was running constantly and barely staying cold. The technician cleaned the condenser coils, replaced the start relay, and checked the door seals. $225 total and the fridge is…”
Kenmore dryer not heating is typically caused by burned out heating element or blown thermal fuse. Kenmore-specific factor: manufacturer identification critical — 110 series (whirlpool) heating element differs from 796 series (lg) dual-coil design. Repair costs $100-$350 with free diagnostic and 90-day warranty.
Manufacturer identification critical — 110 series (Whirlpool) heating element differs from 796 series (LG) dual-coil design
Thermal fuse failure common across all platforms from restricted dryer vent — universal safety component
Whirlpool-made 110: single coil element (279838) and cycling thermostat are top failure points
LG-made 796: dual coil element with independent failure per coil — partial heat loss common
Electrolux-made 417: heating element access requires full front panel removal
Other Kenmore models may also be affected. Book a free diagnostic for confirmation.
Seeing one of these codes? It likely indicates not heating.
Bay Area Kenmore dryer heating failures follow the parent brand pattern — the technician must identify the manufacturer before ordering parts. In multi-unit San Francisco buildings, shared vent systems create back-pressure that blows thermal fuses regardless of the OEM platform. Whirlpool-made 110 series are the most common Kenmore dryers in Bay Area rental properties — landlords installed them for reliability during the 2005-2018 Sears era.
Identify manufacturer from model prefix: 110/600 = Whirlpool, 796/970 = LG, 417 = Electrolux — determines diagnostic and parts
Test thermal fuse on all platforms: continuity check — 0 ohms is good; open circuit means blown fuse plus mandatory vent inspection
For Whirlpool 110: test element 279838 for continuity — should read 8-15 ohms; access by removing rear panel
For LG 796: run Flow Sense diagnostic (hold Dry Level + Time Dry 3 seconds) to check vent restriction before testing components
Kenmore dryer heating repairs start with manufacturer identification from the model number. Thermal fuse testing is universal across all platforms — the technician checks this first regardless of OEM. If blown, the vent is cleaned before fuse replacement. Element replacement procedures vary by platform: Whirlpool 110 series element is accessed from the rear panel (30-40 minutes), LG 796 series requires front panel and drum removal (60-75 minutes). Sacramento calls always include vent airflow verification at the exterior cap.
| Diagnostic | Free |
| Typical repair | $100–$350 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Kenmore Expert
Brand-specific diagnostic tools and training
Same-Day Fix
Available in Bay Area
90-Day Warranty
Guaranteed parts and labor
Free diagnostic for not heating issues. Same-day service in Bay Area.
Book Free DiagnosticSamsung dryer kept shutting off after ten minutes in San Mateo. Technician found the thermal fuse had blown due to a clogged exhaust vent. Replaced the fuse and cleared the vent — works perfectly now.
Whirlpool gas dryer was producing no heat at all in our Hayward apartment. Tech found the gas valve solenoid had failed and replaced it on the first visit. Clothes come out warm and dry in one cycle.
Verified reviews from homeowners across San Francisco and Bay Area
“Sub-Zero 36-inch built-in with a noisy compressor. Compressor mounts were worn causing vibration. Mounts replaced and compressor serviced for $295. Fridge is quiet and cooling perfectly. Sub-Zero expertise is rare and valuable.”
Tammy B.
Refrigerator Repair
Palo Alto, CA
“Our Samsung dishwasher was leaking from the bottom. The technician found a loose hose clamp on the circulation pump. It was a simple fix for $120 — I really appreciated the honesty since they could have sold me a new pump. The dishwasher has been leak-free since. Trustworthy company.”
Yuki N.
Dishwasher Repair
San Mateo, CA
“KitchenAid built-in refrigerator was forming puddles underneath. Clogged defrost drain was sending water out the bottom instead of into the drain pan. The tech cleared the drain, added a drain heater clip to prevent recurrence, and cleaned the drain pan. $175 for a fix that eliminated a really annoying problem.”
Alicia R.
Refrigerator Repair
Palo Alto, CA
“Our LG French door refrigerator stopped cooling overnight. With a fridge full of food, we needed emergency service. The tech came same-day, diagnosed a failed compressor relay, and had it running in under an hour. He also told us about LG's compressor warranty which covered the part. Outstanding service.”
Anthony R.
Refrigerator Repair
Sunnyvale, CA
“Our 20-year-old Sub-Zero had a warm refrigerator section. The tech was clearly experienced with Sub-Zero — he diagnosed a failing evaporator fan and weak door gaskets. Replaced both, cleaned the condenser, and the unit is performing like new. $520 for a repair on a unit worth $15K+ to replace. No-brainer.”
Richard Y.
Refrigerator Repair
Cupertino, CA
“Called EasyBear on a Sunday morning when my Samsung fridge stopped cooling. A technician arrived by early afternoon, diagnosed a failed evaporator fan motor, and had it replaced within 90 minutes. Food saved, stress gone. The $265 was absolutely worth it.”
Karen L.
Refrigerator Repair
San Francisco, CA
“Whirlpool fridge compressor running non-stop. Dirty condenser coils were the culprit. Thorough cleaning for $95 service fee. Compressor now cycles normally and energy bill dropped.”
Dave K.
Refrigerator Repair
Daly City, CA
“The technician arrived within 2 hours of my call and diagnosed the issue immediately — a faulty defrost timer causing ice buildup. He had the part on his truck and fixed it in under an hour. My fridge has been running perfectly for 3 months now. Very reasonable price at $275.”
Sarah M.
Refrigerator Repair
San Francisco, CA
“GE upright freezer was running but not getting below 25°F. The evaporator fan motor was failing. Tech replaced it and also checked the defrost system which was still working fine. $210 total and the freezer is back to 0°F. Saved about $800 in frozen food that would have spoiled. Worth every penny.”
Raymond G.
Freezer Repair
San Francisco, CA
“Our chest freezer stopped freezing and we had hundreds of dollars of meat inside. Called at 8am and the tech arrived by 10:30am. Faulty thermostat was the culprit — replaced in 30 minutes. Saved all our food! Cost was $175. Can't thank them enough for the fast response.”
Amanda J.
Freezer Repair
Concord, CA
“Finding someone experienced with Sub-Zero was tough until I found this company. Our 15-year-old Sub-Zero was running constantly and not cooling. The tech cleaned the condenser, replaced the fan motor, and it's been running like new. Worth every penny of the $450 repair — a new Sub-Zero is $12,000+.”
James C.
Refrigerator Repair
Berkeley, CA
“The notorious Samsung ice maker problem struck our French door fridge. The tech was very familiar with this specific issue, performed the recommended fix including defrosting the evaporator and installing a new ice maker kit. It's been 6 weeks and still working great. $350 well spent.”
Wei Z.
Refrigerator Repair
Cupertino, CA