Want a regional phone & address? Pick your area.
Maytag·Washerlow severity
Maytag Error Code F8 E2
Dispenser motor fault
Common Causes
- 1Detergent buildup in dispenser mechanism
- 2Dispenser motor failure
- 3Dispenser actuator jammed
Step-by-Step Troubleshooting
- 1
Remove dispenser drawer and clean all detergent/fabric softener residue
- 2
Run hot water through the dispenser housing
- 3
Check that the dispenser actuator moves freely
- 4
If motor still does not operate, replace the dispenser motor
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$75–$200
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
Dispenser motorDispenser assembly
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Clean dispenser drawer
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F8 E2 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Maytag error code F8 E2 mean?
Maytag error code F8 E2 indicates: Dispenser motor fault. This is a low-severity issue affecting your washer.
How do I fix Maytag error code F8 E2?
Remove dispenser drawer and clean all detergent/fabric softener residue Then, Run hot water through the dispenser housing Then, Check that the dispenser actuator moves freely There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How much does it cost to fix Maytag F8 E2?
Repair costs for Maytag F8 E2 typically range from $75 to $200 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.