Want a regional phone & address? Pick your area.
Maytag·Washermedium severity
Maytag Error Code F8 E1
Water supply error - not filling
Common Causes
- 1Water supply valves closed
- 2Inlet hose kinked
- 3Inlet screen clogged
- 4Low household water pressure
- 5Water inlet valve failure
Step-by-Step Troubleshooting
- 1
Turn both hot and cold water faucets fully on
- 2
Inspect inlet hoses for kinks behind the washer
- 3
Remove hoses and clean the small mesh screens at the valve inlet
- 4
If screens are clean and faucets are open, the inlet valve may need replacement
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$75–$225
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
Water inlet valve (W11165546)
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Check both water supply valves
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F8 E1 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Maytag error code F8 E1 mean?
Maytag error code F8 E1 indicates: Water supply error - not filling. This is a medium-severity issue affecting your washer.
How do I fix Maytag error code F8 E1?
Turn both hot and cold water faucets fully on Then, Inspect inlet hoses for kinks behind the washer Then, Remove hoses and clean the small mesh screens at the valve inlet There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How much does it cost to fix Maytag F8 E1?
Repair costs for Maytag F8 E1 typically range from $75 to $225 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.