Want a regional phone & address? Pick your area.
GE·Refrigeratorhigh severity
GE Error Code CC
Compressor control error
Common Causes
- 1Compressor relay failure
- 2Inverter board issue
- 3Compressor motor fault
Sealed system work (compressor replacement) requires EPA Section 608 certification for refrigerant handling. Do not attempt DIY. Bay Area and Sacramento labor rates for sealed system repair run $400-600 on top of parts.
Step-by-Step Troubleshooting
- 1
Unplug unit and wait 5 minutes before diagnostics
- 2
Check inverter board for visible burn marks or swollen capacitors
- 3
Test compressor windings with multimeter — run-to-start and run-to-common resistance should match spec
- 4
Check compressor relay and overload protector for continuity
- 5
Measure voltage at inverter board output during startup attempt
- 6
If compressor windings test open or shorted, compressor replacement is required
Pro Diagnostic Tip
GE variable-speed compressors (Profile/Monogram) fail at the inverter board 3x more often than the compressor itself. Test inverter first — it is significantly cheaper. Listen for compressor click-buzz-off pattern which indicates locked rotor vs inverter fault.
You Might Also Notice
- •Refrigerator not cooling at all
- •Clicking sound from back of unit
- •Compressor starts then immediately stops
Parts, Cost & Difficulty
Repair Difficulty
Professional OnlyEstimated Repair Cost
$350–$900
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
WR87X29409 inverter boardWR07X10097 compressor relay/overload kitWR87X10226 compressor (sealed system repair)
Do You Have the Right Tools?
Refrigerant gauges ($200+), vacuum pump ($250), leak detector ($150), and EPA-certified recovery equipment. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
Refrigerant (R-134a/R-600a) requires EPA certification to handle. Improper discharge is a federal violation and health hazard. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Get Professional Help Now
Error code CC is a high-severity issue that can cause further damage to your refrigerator if left unresolved. A licensed technician can diagnose and fix it the same day.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does GE error code CC mean?
GE error code CC indicates: Compressor control error. This is a high-severity issue affecting your refrigerator.
How do I fix GE error code CC?
Unplug unit and wait 5 minutes before diagnostics Then, Check inverter board for visible burn marks or swollen capacitors Then, Test compressor windings with multimeter — run-to-start and run-to-common resistance should match spec There are 3 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my refrigerator has error CC?
Besides the error code on the display, common signs include: Refrigerator not cooling at all; Clicking sound from back of unit; Compressor starts then immediately stops. If you notice any of these symptoms, check your refrigerator's display panel for error code CC.
How much does it cost to fix GE CC?
Repair costs for GE CC typically range from $350 to $900 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.