Want a regional phone & address? Pick your area.
Electrolux·Refrigeratorhigh severity
Electrolux Error Code SH
Freezer sensor shorted
Common Causes
- 1Sensor wire short circuit
- 2Damaged sensor
- 3Moisture in connector
Step-by-Step Troubleshooting
- 1
Locate the freezer thermistor (clipped to evaporator or wall)
- 2
Measure sensor resistance — should read ~32K ohms at 0F, ~16K at 32F
- 3
If reading near 0 ohms, sensor wires are shorted — trace for damage
- 4
Check connector at board for moisture or corrosion (common in high-humidity areas)
Pro Diagnostic Tip
Electrolux uses NTC thermistors with a known resistance curve; a reading under 1K ohms at any normal temperature confirms a short — do not confuse with OP (open) code
You Might Also Notice
- •Freezer runs continuously without stopping
- •Everything freezes solid including fresh food
- •Temperature display shows extreme low value
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$80–$200
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
241798224 — Freezer thermistor sensor242047805 — Sensor harness
Do You Have the Right Tools?
Refrigerant gauges ($200+), vacuum pump ($250), leak detector ($150), and EPA-certified recovery equipment. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
Refrigerant (R-134a/R-600a) requires EPA certification to handle. Improper discharge is a federal violation and health hazard. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Get Professional Help Now
Error code SH is a high-severity issue that can cause further damage to your refrigerator if left unresolved. A licensed technician can diagnose and fix it the same day.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Electrolux error code SH mean?
Electrolux error code SH indicates: Freezer sensor shorted. This is a high-severity issue affecting your refrigerator.
How do I fix Electrolux error code SH?
Locate the freezer thermistor (clipped to evaporator or wall) Then, Measure sensor resistance — should read ~32K ohms at 0F, ~16K at 32F Then, If reading near 0 ohms, sensor wires are shorted — trace for damage There are 1 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my refrigerator has error SH?
Besides the error code on the display, common signs include: Freezer runs continuously without stopping; Everything freezes solid including fresh food; Temperature display shows extreme low value. If you notice any of these symptoms, check your refrigerator's display panel for error code SH.
How much does it cost to fix Electrolux SH?
Repair costs for Electrolux SH typically range from $80 to $200 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.