Want a regional phone & address? Pick your area.
Electrolux·Dishwashermedium severity
Electrolux Error Code i10
Water supply error
Common Causes
- 1Water supply turned off
- 2Inlet hose kinked
- 3Inlet valve clogged
Step-by-Step Troubleshooting
- 1
Verify hot water supply valve under sink is fully open
- 2
Inspect inlet hose for kinks or damage
- 3
Clean inlet valve screen filter (remove hose, check mesh)
- 4
Test water pressure — Electrolux dishwashers need 20-120 PSI
Pro Diagnostic Tip
Run hot water at the kitchen sink before starting a cycle to prime the line; if i10 persists, the inlet valve solenoid is likely stuck
You Might Also Notice
- •Dishwasher does not fill
- •Cycle starts then stops immediately
- •Low water level in tub
Parts, Cost & Difficulty
Repair Difficulty
Easy — DIY FriendlyEstimated Repair Cost
$80–$200
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
807131901 — Water inlet valve5304517871 — Inlet hose assembly
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Diagnose the root cause, test affected components with calibrated meters, replace faulty parts with OEM replacements, and verify proper operation through a full test cycle.
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code i10 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Electrolux error code i10 mean?
Electrolux error code i10 indicates: Water supply error. This is a medium-severity issue affecting your dishwasher.
How do I fix Electrolux error code i10?
Verify hot water supply valve under sink is fully open Then, Inspect inlet hose for kinks or damage Then, Clean inlet valve screen filter (remove hose, check mesh) There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How do I know if my dishwasher has error i10?
Besides the error code on the display, common signs include: Dishwasher does not fill; Cycle starts then stops immediately; Low water level in tub. If you notice any of these symptoms, check your dishwasher's display panel for error code i10.
How much does it cost to fix Electrolux i10?
Repair costs for Electrolux i10 typically range from $80 to $200 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.