The short answer
What this symptom means on a Vezeni dishwasher depends on how the dishwasher is built, and on this one the order runs like this. First — The way the machine is loaded. Last, and the only one that is a technician's job from the outset — A wash pump that has lost pressure. Start at the top: those checks are free and need nothing opened.
What you actually observe
- Items come out with food still on them — The clearest version of the complaint.
- A gritty deposit on the load — Debris being recirculated rather than trapped.
- A greasy film on glass and plastic — A heat and detergent story rather than a spray one.
- NEAR MISS: everything is clean but wet — That is drying and rinse aid, and it belongs on a different page.
Causes, most likely first on this build
- The way the machine is loaded — A dishwasher washes what the water can reach. A pan shadowing a whole rack, or a bowl turned the wrong way, leaves items that never see a jet, and the machine takes the blame for geometry. Ranked first on a Vezeni: a countertop unit sits in the warmest air in the kitchen, right beside the things that make the kitchen warm.
- A filter that has not been cleaned — The filter traps food so it is not sprayed back onto the load. Second here, because a hand-filled, hand-emptied unit depends on the owner's routine more than on any part inside it.
- No rinse aid — Rinse aid changes how water leaves the load, and without it water beads and dries in place. Third, once the two above are clean: it is free, immediate, and it decides whether this is a fault at all.
- A wash pump that has lost pressure — The pump provides the force behind every jet. Last, and the reason the order above matters: it is the rarest cause and the only one that is not an owner fix on a unit this small.
Check in this order, and why
- Look at the load from where the spray arms are — Anything in a shadow is not being washed.
- Take the filter out and look at it — It is owner-serviceable and it is usually the answer.
- Check the rinse aid indicator — Spotting and film are drying faults, not washing ones.
What an owner can safely check
- Check the tap adapter is fully seated and the drain hose is hooked properly over the sink — A countertop machine is coupled by hand for every wash, and that is the joint that leaks or fails to fill.
About 10 min
- Take out the filter at the bottom of the tub, rinse it under the tap and refit it — This is designed as owner maintenance and it is the single most effective step on the list.
Tools: warm water, a soft brushAbout 15 min
- Spin both spray arms by hand and clear every blocked hole with a cocktail stick — An arm that cannot turn, or half of whose jets are blocked, washes only part of the load.
Tools: a cocktail stickAbout 15 min
- STOP HERE if the arms turn freely, the filter is clean and the wash is still weak — A failing wash pump needs a technician, and that is where an owner check ends.
Before you open anything
Safety
Switch the machine off at the isolating switch under the worktop, or unplug it, before opening any panel, and shut the supply valve under the sink. A capacitor can hold a charge after the power is off.
When to call a technician
Call when the filter is clean, both arms spin freely with clear jets, the water arrives hot and a full programme with fresh detergent still leaves the load dirty. That points at the wash pump, which is the one cause here that is not free to fix.
Where to go next in this class
What is deliberately not on this page
This page is written for the Vezeni dishwasher as a class, not for one family or model line. Where a family- or model-specific page exists for your machine it is linked above, and it is the more specific answer. Deliberately not here: error-code tables, pump and board part numbers and any plumbing specification for your installation.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
