The short answer
This class of cabinet is not built with an ice maker, so the real question is why the freezer shelf is not freezing a tray. Ranked first on this platform: The cabinet has no automatic ice maker at all. The checks below follow that ranking, and the first of them need no tools and no panel removed.
What you observe
- There is no ice bin, no bail arm and no water connection anywhere on the cabinet — A cabinet with no water line was never going to make ice on its own.
- The fridge section is perfectly cold and only the freezer shelf underperforms — A split like that on a single-control cabinet is the control, not a component.
- A thick layer of frost on the plate and a tray that takes all day — Frost on the plate and slush in the tray is one fault seen from two sides.
- NEAR MISS — the tray freezes but the ice tastes of the cabinet — That is an odour and storage question rather than a production one, and a covered tray solves it.
Causes, most likely first on this platform
- The cabinet has no automatic ice maker at all — A compact cabinet of this class is not built with an ice maker. It ranks first on this platform because there is no ice maker, no water line and no harvest cycle on a cabinet of this size, which means every part of the usual ice-maker fault list is irrelevant here and the complaint is a temperature one.
- A temperature control set too warm for freezing — One dial serves both compartments on a compact cabinet. It ranks second here because the temperature control is a mechanical bulb thermostat with a dial, not a sensor and a board, so it drifts rather than throwing a code.
- Frost on the freezer plate instead of ice in the tray — On a manual-defrost compact, the plate is both the cooling surface and the frost collector. It sits third because the causes above it account for more of these cases, not because it is unlikely.
Check in this order, and why
- Establish whether there is a water connection behind the cabinet at all — It redirects the whole diagnosis from a water fault to a temperature one. It leads because it tests the top-ranked cause.
- Turn the control colder by one step and give it a full day — One step at a time is the only way to find the setting that serves both compartments. Tests the second-ranked cause.
- Look at the thickness of the frost on the plate before anything else — Anything more than a light fur is enough to explain the complaint. Tests the third-ranked cause.
What an owner can safely check
- Fill a tray with cold water, set it flat on the freezer shelf and leave it overnight — A tray that does not freeze solid overnight is a temperature problem; a tray that does means the cabinet is fine.
About 15 min
- Move the dial one step colder and leave a tray of water in overnight — Judge it by the tray rather than by the dial.
About 15 min
- STOP at the first panel that needs a tool, and write up what you found — A technician who arrives knowing which checks came back clean spends the visit fixing rather than repeating them.
Before you work on the water side
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off.
When to call a technician
Call if the compartment will not reach a freezing temperature after the control, the frost and the room have all been dealt with, because what is left is the cooling system itself.
Nearest pages of this class
What this page does not cover
This page is written for the MicroChill refrigerator as a class, not for one family or one model line. Where a family- or model-specific page exists for your unit, that page is the more specific answer and the one to read first. Deliberately not here: part numbers, wiring colours and disassembly order, which differ by family.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
