The short answer
On an Inglis dryer, a new noise from a machine that still runs is usually worn drum support rollers rather than a failed rear drum bearing. The next thing to rule out is a dry or worn idler pulley. Most causes below are owner checks needing no tools and no panel off; the last is a service call.
What you are looking at
- A squeal in the first minute from cold — It fades as the machine warms up.
- A rattle like a stone in a can — It comes from the fan side rather than the drum.
- A sharp regular tick on every rotation — It follows the drum rather than the cycle.
- NEAR MISS -- a squeal plus no heat — Treat the heat fault first; it points at the vent.
Causes, most likely first on this kind of unit
- The drum support rollers are worn — Rollers carry the drum's weight. Worn flat, they give a heavy rhythmic rumble or thump that rises with drum speed and is worst with a load in. First here, because on an Inglis machine: simple controls over standard full-size mechanicals rollers are the wear part of this drivetrain, and a rumble that tracks the drum is their signature.
- The idler pulley is dry or worn — The pulley that tensions the belt squeals or chirps, loudest at start-up and when cold. It is a small part with a very distinctive sound. Ranked here because a squeal that is worst at start-up and eases when warm is the idler.
- Something is loose in the drum or blower — Coins, buttons and zip pulls fall out of pockets and end up in the drum seam or the blower housing. You get a sharp regular tick or a metallic rattle that changes with speed. Ranked here because a metallic tick that follows the drum is loose debris, not wear.
- The rear drum bearing — A dry rear bearing roars or grinds and rises with speed. It needs the machine opened and the drum out, and it is the repair whose cost decides an older machine's future. Last, and that is the point of the order: it is last because every cheaper sound above has to be eliminated first.
Check in this order, and why
- Note whether the rumble tracks drum speed — A rumble that rises steadily with the drum, worst under load, points at the rollers.
- Listen at start-up from cold — A squeal or chirp in the first minute that fades as the machine warms is the idler.
- Only after the checks above are clean — A roar that rises with drum speed, with an empty clean drum and a level machine, is a service call.
What an owner can safely check
- Empty the drum and turn it slowly by hand — Listen for anything sliding in the seam, and feel for roughness.
Tools: flashlightAbout 15 min
- Check the drum seam and the lint housing for coins — Reach into the filter housing with the machine unplugged.
About 15 min
- Set the feet and open the gap to the neighbouring machine — Cabinet contact is free to fix and it removes the most common false alarm.
Tools: levelAbout 15 min
- STOP HERE -- do not open the cabinet — Rollers, pulleys, belts, blowers and bearings are technician work.
Before you open anything
Safety
Unplug the dryer or switch off its breaker before any panel comes off. If it is a gas dryer and you smell gas: do not switch anything on or off, leave the building, and call the gas utility or emergency services from outside -- do not look for the leak yourself.
When to call a technician
Call once the lint filter, the full vent run and the door switch are ruled out.
Nearest pages of this class
What this page does not cover
This page covers the Inglis dryer as a class, not one family or model line. Where a family- or model-specific page exists for your unit it is the more specific answer -- go there first if your model is named. Deliberately not here: roller kits, pulley part numbers, belt sizes and the panel-removal order, all of which differ by family.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
