The answer first
On a Gorenje dryer, a machine that is completely dead is usually a supply problem or an open thermal fuse, and the fuse opens because a vent was blocked rather than because the fuse failed. A machine that hums without turning is a broken belt or a seized part. A machine that lights but will not run is nearly always the door switch.
What you are seeing
- Nothing at all happens — no lights, no sound — A supply problem or an open thermal fuse in the control path.
- The machine hums but the drum does not move — A broken belt or a seized motor or blower.
- The panel lights but the cycle will not begin — Almost always the door switch or the start contact.
- NEAR MISS: it runs the full cycle and the clothes stay wet — That is a heating or airflow fault and belongs on the page for a dryer that does not dry.
Causes ranked for this machine
- A door switch or catch not making — The machine will not start with the door reading open, and a worn catch or a lint-packed strike leaves the switch a fraction short of closing. Ranked first on a Gorenje dryer: European cycle logic is long and gentle, so a partial fault is tolerated for weeks and only the end of it is visible.
- A tripped breaker or a lost supply leg — An electric dryer runs from two breaker positions, so losing one can leave a machine that is dead, or one that runs without heating. Ranked second on a Gorenje dryer: the machine is designed to work around a problem rather than stop, so by the time you see a symptom the cause has been there a while.
- A start switch or control that has failed — The start contact carries the motor start current and wears, so a machine that responds to every other key but not to start is a familiar pattern. Ranked third on a Gorenje dryer: the control runs an adaptive cycle, so it will extend and retry around a fault rather than stop and tell you.
What to check first, second and third
- Close the door firmly and listen for a click, then press and hold while starting — A machine that starts only under pressure has a switch or catch that is only just making.
- Check both breaker positions for the dryer, not just one — A double breaker can trip on one side and look closed at a glance.
- Try every key and note which produce a response — Everything working except start points at the switch rather than the board.
The checks you can make yourself
- Clean the door catch and strike thoroughly, then close firmly and retry — Lint packs into the catch recess and holds the door a fraction open.
Tools: cloth, torchAbout 10 min
- Switch the dryer breaker fully off and back on, then retry the machine — A breaker that trips again immediately is protecting the circuit and means stop.
About 10 min
- STOP HERE if the machine hums without turning and the belt is intact — Repeated attempts on a seized motor overheat the winding and can start a fire.
Safety first
Safety
Unplug the dryer or switch off its breaker before opening any panel. Do not keep pressing start on a machine that hums without turning: a stalled motor draws heavily and overheats its winding. Never bypass a door switch or a thermal fuse — the fuse opened because something overheated, and defeating it removes the protection that stopped a fire. On a gas dryer, if you smell gas, leave the building and call the utility from outside.
Where the owner job ends
Call once the breaker is proven, the door catch is clean, the belt is intact and the machine still will not run — the fuse, the motor and the start circuit all sit behind the cabinet at live terminals. Call immediately, and leave the machine unplugged, if it hums and will not turn, if it trips the breaker, or if anything smells hot.
Related pages for this machine
What is deliberately not here
This page covers the Gorenje dryer as a class, not one family or model line. Part numbers, wiring colours, torque figures and panel fixings differ from build to build and are deliberately not here. Where a family- or model-specific page exists for your unit, that page is the more specific answer and should be read first.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
