The short answer
On Fisher & Paykel a machine that will not start is most often a programme that was never fully entered. Ranked that way because the door and its interlock stack are the part the owner operates thousands of times, and they wear accordingly.
What you observe
- The display lights but start does nothing — Points at the door latch, a lock, or an incomplete programme entry.
- It beeps once and refuses every press — Usually a child lock or a demonstration mode, both of which survive a power cut.
- NEAR MISS: it starts and runs but the food stays cold — That is a heating fault rather than a starting one, and it has its own page.
Causes, most likely first on Fisher & Paykel
- The programme was never fully entered — First here, where a modulating control hides a developing fault rather than announcing it. Many machines need a time or a programme entered before start does anything, and a cancel pressed mid-entry leaves the display lit and the machine waiting. It reads exactly like a fault and is not one.
- The door is not latching onto its interlocks — Second, and the cause this control is least able to tell you about. A microwave will not begin until every interlock confirms the door is shut, and the plastic hooks that press them wear. A door that must be pushed hard, or held, is describing this directly.
- There is no power at the machine — Third. A tripped breaker, an outlet switched off behind a built-in machine, or a plug that has worked loose.
- The keypad, an interlock switch or the control board has failed — Last, and it is the reason the order above matters. Power is confirmed, no lock is set, the programme is entered and the door latches, and nothing happens.
Check in this order, and why
- Enter a short time on a standard programme, then press start — It costs nothing and it resolves a genuine share of these outright.
- Close the door normally and note whether it catches first time, every time — It is the most common reason a healthy microwave does nothing, so it goes first.
- Look at the display: dark is power, lit is not — One glance splits the whole list in two, which is why it comes early.
What an owner can safely check
- Press cancel, enter a short time on full power, and press start — A machine that runs this way was never faulty.
About 5 min
- Clear the latch throat of crumbs, then close the door normally several times — Never tape or pack the latch: the interlock is a safety part, not an inconvenience.
Tools: damp clothAbout 10 min
- Check the breaker and the outlet, and reseat the plug if you can reach it — A breaker that trips again straight away is a fault.
Tools: torchAbout 15 min
- STOP HERE if the next step needs a meter on live terminals — That is where an owner check ends and a service call begins.
Before you open anything
Safety
Never open the outer casing of a microwave: the high-voltage capacitor can hold a lethal charge long after it is unplugged. Never tape, pack or bypass a door interlock to make a machine start. Switch the breaker off before reaching behind a built-in machine, and never reset a breaker a second time once it has tripped twice on the same appliance.
When to call a technician
Call, or replace the machine, when power is confirmed, no lock is set, a programme is entered, the door latches and it still does nothing, because that puts the fault in an interlock switch, the keypad or the control. Call immediately, with the breaker off, if it trips the breaker when power is restored or if anything smells hot.
Nearest pages of this class
What this page does not cover
This page covers the brand and the microwave class, not one family or model line. Where a family-specific or model-specific page exists for your unit, that page is the more specific answer and it takes precedence over this one. Not here: part numbers, wiring colours and component locations, which differ by family.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
