The short answer
The Crosley CDBEH family is the broadest Crosley dishwasher line in this set — the matrix below spans several series — and that matters for a cleaning complaint, because the series decides what your machine actually has: how the filter is arranged, and how it dries. Read the designation from the plate inside the door frame first, then work through water temperature, spray arms and the filter, which are the causes on every one of them.
What you observe
- Food left on the lower rack after a full cycle — Water temperature, a blocked arm, or a restricted filter.
- One section clean and another untouched — A spray arm that cannot complete a turn, usually because of the load.
- Dishes clean but wet at the end — Rinse aid, loading, or simply the drying arrangement your series uses.
- A white film on glassware — Hard water and dosage rather than a fault.
- NEAR MISS — dirty dishes with water still in the sump — That is drainage, and the drainage page covers it.
Causes, most likely first on this family
- Inlet water not hot at the start of the cycle — First across every series here: the tap runs hot long before the machine does, and a cold first fill wastes the main wash.
- Spray arms blocked or unable to turn — Second, and the load is usually the reason rather than the machine.
- Filter or sump restricted — Third, and the cause most affected by which series you own — check whether yours has a filter the owner is meant to remove.
- Rinse aid and the drying arrangement — Fourth. Wet dishes are a drying complaint, and across this family the expected result is not the same on every series.
- Wash pump wear or a restricted inlet — Last, and a fading-over-months story rather than a sudden one.
Check in this order, and why
- Read the full designation from the plate — On the widest family in this line it decides what your machine is supposed to do and which parts fit.
- Run the kitchen tap hot, then start a cycle — Free, immediate, and frequently the whole answer.
- Spin both arms by hand and clear their holes — Identifies the blocked-arm case in a minute.
- Check the filter or sump area and the rinse aid — Left until here because it depends on what your series has.
Before you open anything
Safety
Switch off the dishwasher at its breaker before removing the kick panel or the pump access; a capacitor can hold a charge after the power is off, and the junction box under these machines shares its space with the water. Shut the supply valve under the sink first, expect standing water in the sump, and never bypass the door latch switch to run the machine open.
Models in the CDBEH family
Reference| Model number | Family key |
|---|---|
| CDBEH351**** | crosley:dishwasher:cdbeh |
| CDBEH600***A | crosley:dishwasher:cdbeh |
| CDBEH650***A | crosley:dishwasher:cdbeh |
| CDBEH950***A | crosley:dishwasher:cdbeh |
| CDBEH960**** | crosley:dishwasher:cdbeh |
When to call a technician
Loading, hot-water priming, arm clearing, filter cleaning and dosage are owner work. Call a technician when the arms barely turn with a clean filter, when the wash sounds weak, or when performance has faded steadily with all the above correct. Call at once if the machine trips a breaker or smells hot.
Nearest pages of this class
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
