The short answer
When a Care CED dryer gets loud, check the pockets before the parts. Coins that pass the lint screen reach the blower wheel and make a tick or a rattle that is easy to mistake for a bearing, and they are free to remove once located. This family resolves to one model tag in the matrix below, which makes the platform question simple — there is no second revision behaving differently.
What you can observe on these models
- A rumble or thump that keeps time with the drum — The drum supports: rollers, their shafts, or the rear bearing depending on design. It rises and falls with the drum, not with anything else.
- A squeal or chirp that starts with the cycle — The belt and its idler pulley. It often appears from cold and fades as the machine warms, which is characteristic.
- A tick, rattle or scrape that does not follow the drum — The blower wheel, usually with a coin or a button in it. The blower runs faster than the drum, so the rhythm is obviously different.
- A scraping that changes when the machine is loaded — Worn front glides or a felt seal letting the drum sit against the bulkhead. Load changes the contact and so it changes the sound.
- NEAR MISS — a rhythmic clunk that stops when the pockets are emptied — Coins and zips in the drum sound alarming and are not a fault at all.
Causes, most likely first on this family
- An object in the blower wheel — First on urgency as much as on frequency. The sound is distinctive because the blower turns faster than the drum, so the rhythm does not match.
- Worn drum rollers or support wheels — Second. They carry the drum through every cycle and they harden, flat-spot and seize with age, producing a rumble that tracks the drum exactly and is usually worse with a heavy load.
- The belt or the idler pulley — Third, and easy to confirm by ear: it starts with the cycle rather than with the load, and it often quietens as the machine warms.
- Front glides or a felt seal that has worn through — Fourth. The drum runs on glides at the front and a felt seal at the back; when either wears the drum contacts metal and scrapes, and the sound changes with load because the load changes where the drum sits.
- The motor bearing — Last, and a diagnosis of exclusion once the drum turns smoothly by hand and the blower is clear.
Check in this order, and why
- Empty the drum and check the pockets — Coins and zips in a load produce a clunk that owners reliably mistake for a fault. It costs nothing and it ends a real share of noise complaints.
- Run it empty and listen to the rhythm — A noise that keeps time with the drum is the drum; one that is obviously faster belongs to the blower, because the blower spins at a different rate.
- Note whether the noise changes as the machine warms — A squeal that fades after the first minutes is characteristic of the belt and idler, and it distinguishes them from a roller that is indifferent to temperature.
- Only then open the cabinet — Everything above is free and assigns the noise to a place. The panel comes off after that, with the power off, and on a gas machine with the gas valve closed.
Before you open anything
Safety
Disconnect power at the plug or the breaker before any inspection; a capacitor can hold a charge after the power is off. Close the gas valve first on a gas machine. Sharp edges and hot surfaces are both present inside a dryer cabinet, and a blower wheel with a coin in it can have broken edges, so use a torch and a tool rather than fingers.
Models this page covers
Reference| Model number | Family key |
|---|---|
| CED35 | care:dryer:ced |
When to call a technician
The owner side is identification; the service side is access. Rollers, belts, idlers, glides and blower wheels are all ordinary parts, but reaching them means removing panels and supporting the drum, and on a gas machine it means working around a gas train that is not owner territory. A noise accompanied by a smell of burning should be treated as urgent rather than routine.
Other faults covered for this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
