What this family is
The T refrigerator family is listed in the table below. What dominates on this platform is cooling and temperature faults, with ice-making faults behind it.
What goes wrong on these models
- Cooling and temperature faults — the compressor starts, runs a short while, then stops and starts again — See: Alpicool T Refrigerator: Not Cooling or Not Freezing.
- Ice-making faults — it freezes on mains power but not from the vehicle socket — See: Alpicool T Refrigerator: Ice Maker Fault.
- Leaks and water on the floor — water appears under the unit after it has been moved — See: Alpicool T Refrigerator: Water Leak.
- Noise and vibration — a ticking or whirring that rises and falls — See: Alpicool T Refrigerator: Abnormal Noise or Vibration.
Problem classes in frequency order
- 1. Cooling and temperature faults — The usual answer in this class is blocked heat rejection at the condenser. It moves up on T because the three listings grow the cabinet without growing the vent face in proportion, so the largest of them is the tightest for air.
- 2. Ice-making faults — On this platform it is what the box has actually been asked to do, more often than anything else.
- 3. Leaks and water on the floor — On these models the class is led by condensation from warm, humid air.
- 4. Noise and vibration — Led here by the surface underneath it.
Models in the T family — The listings this family covers; it is a family page, not a model page.
Reference| Model number | Family key |
|---|---|
| T36 | alpicool:refrigerator:t |
| T50 | alpicool:refrigerator:t |
| T60 | alpicool:refrigerator:t |
Problem classes on this family — Ordering only: no snapshot behind this family carries a counted denominator, so no share is printed.
General guidance| Problem class | Relative frequency on this family |
|---|---|
| Cooling and temperature faults | first by report |
| Ice-making faults | second |
| Leaks and water on the floor | third |
| Noise and vibration | fourth |
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel; a capacitor can hold a charge after the power is off. Never cut into the sealed refrigerant circuit, and never chip ice off the plate with a blade, because the tubing behind it is thin-walled.
Owner work and technician work
An owner can reach leaks and water on the floor and noise and vibration without a tool beyond a torch and a cloth. The line is crossed as soon as a check needs a meter on live terminals, the sealed system opened, or the cabinet emptied and moved, and it is the same line on every listing in the table.
