Combo unit leaking water? We replace seals, hoses, and valves. Same-day service, 90-day warranty. Average repair cost: $100–$350. Professional service recommended.
Washer Dryer Combo leaking repair typically costs $100 to $350. This repair requires professional tools and expertise. Most repairs are completed in 1-2 hours with a free diagnostic visit.
Saratoga combo leaks center on ADU installation quality on high-value estate properties. Custom estate homes built around 1975 have excellent primary plumbing. San Jose Water Company water at 240 TDS deposits moderate mineral on seals. ADU and guest suite plumbing may be substandard. Extreme property values ($3M median) make leak prevention a high priority.
Saratoga ADU plumbing is the primary leak risk. Primary homes have excellent infrastructure. 240 TDS water deposits moderate mineral. Extreme property values demand proactive leak prevention.
Door boot seal tear
Drain hose leak
Tub seal failure
Inlet valve drip
Condensation overflow
The rubber door gasket endures both hot wash and hot dry cycles in combo units, degrading faster than in standalone washers. Bay Area fog-belt humidity keeps the seal damp between uses, promoting mildew that eats into the rubber surface. Small tears quickly expand under water pressure.
Cost: $160–$320 | Time: 60-90 minutes
Vibration during spin cycles works drain hose clamps loose over time. In Bay Area closet installations where the hose is routed through tight bends, stress at connection points creates pinhole leaks. Water appears under or behind the unit during drain cycles.
Cost: $80–$180 | Time: 25-40 minutes
Ventless combo units collect condensation in an internal reservoir or route it to the drain. When the condensation channel clogs with lint, water overflows internally and drips from the bottom. This leak only occurs during drying cycles — a key diagnostic clue.
Cost: $100–$200 | Time: 35-55 minutes
The tub seal around the drum shaft can degrade from the dual heat-wash exposure unique to combo units. Water seeps past the seal during operation and drips onto the motor or floor. Inlet valves may also drip when failing to close completely after fill.
Cost: $150–$300 | Time: 60-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $100–$350 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
This repair involves electrical components or sealed systems requiring professional tools and certification.
Combo leak repairs in Saratoga cost $100-$350. The city has 4 providers with San Jose coverage. Service calls cost $89-$150, diagnostic waived with repair.
In Saratoga, wide day-night temperature swings (30f+ delta) stress thermal expansion joints, thermostat cycling, and sealed-system pressures. This can affect your appliance's control board relay: thermal cycling stresses solder joints on the relay contacts of the main control board, causing intermittent function switching failures If the unit randomly fails to switch between wash and dry modes, the control board relays may have cold solder joints
Free diagnostic visit for leaking issues. Same-day appointments available in Saratoga.
Book Free DiagnosticReviewed by Diana Kowalski, Laundry Systems Specialist