Verified
“Dryer made a loud squealing noise. Drum rollers and belt were worn. Tech had both parts and finished in 45 minutes.”
Jennifer A.
Dryer Repair
Maytag washer not draining is a known issue affecting MVWB765F series. Our technicians specialize in Maytag-specific diagnostics and repair.
Samsung front-loader was shaking violently during spin cycles at our San Jose condo. Technician rebalanced the drum and replaced worn shock absorbers. Runs whisper-quiet now, even on the second floor.
“Dryer made a loud squealing noise. Drum rollers and belt were worn. Tech had both parts and finished in 45 minutes.”
“Dryer made a loud squealing noise. Drum rollers and belt were worn. Tech had both parts and finished in 45 minutes.”
“Maytag fridge was running nonstop and our electric bill spiked. The condenser coils were covered in dust and pet hair. Tech cleaned the coils, replaced a worn door gasket, and the fridge now cycles…”
“Maytag top-loader wouldn't spin. Arthur replaced the lid switch assembly and the motor coupling. Both parts on his truck. Machine spins perfectly again. Saved us from buying a new washer.”
“Maytag gas oven igniter glowing but not lighting the gas. Weak igniter replaced for $165. Oven lights within 30 seconds now instead of clicking for 5 minutes. Great improvement.”
Maytag washer not draining is typically caused by clogged drain pump filter or failed drain pump. Maytag-specific factor: belt-driven pump wear on older models — belt stretches and slips under drain pump load. Repair costs $100-$300 with free diagnostic and 90-day warranty.
Belt-driven pump wear on older models — belt stretches and slips under drain pump load
Electronic drain valve stuck from mineral deposits or debris
Drain pump motor burnout from running against clogged filter
Pressure switch tube clog causing false water level signal
Drain hose internal collapse from heat degradation or pinching behind unit
Other Maytag models may also be affected. Book a free diagnostic for confirmation.
Seeing one of these codes? It likely indicates not draining.
Bay Area Maytag drain issues in older buildings follow the same patterns as Whirlpool — shared drain infrastructure in multi-unit buildings creates backpressure. Older Maytag models with belt-driven pumps are still common in Bay Area laundry rooms of apartment buildings built in the 1990s-2000s. Belt replacement is a routine service item that extends pump life.
Access drain pump filter on front-loaders: open lower front panel, twist filter counterclockwise — have towels and pan ready for water release
Check drain pump operation: run diagnostic drain cycle (same as Whirlpool diagnostic mode), listen for pump motor hum and water evacuation
On belt-driven models: remove rear panel, inspect belt tension and condition — should deflect about 1/2 inch with moderate finger pressure
Test pressure switch: disconnect tube at tub, blow gently — should hear switch click; no click means clogged tube or failed switch
Front-loader filter cleaning resolves most Maytag drain complaints — the technician clears debris, inspects the impeller, and runs a test drain cycle. If the pump motor is failed, the same Whirlpool-pattern pump assembly is used — replacement takes 30-40 minutes. For belt-driven older models, belt and pump replacement is performed as a pair to prevent immediate recurrence. The repair takes about 45 minutes.
| Diagnostic | Free |
| Typical repair | $100–$300 |
| Repair time | 1-1.5 hours |
| Warranty | 90 days parts + labor |
Maytag Expert
Brand-specific diagnostic tools and training
Same-Day Fix
Available in Bay Area
90-Day Warranty
Guaranteed parts and labor
Free diagnostic for not draining issues. Same-day service in Bay Area.
Book Free DiagnosticWhirlpool top-loader stopped draining mid-cycle and flooded our Sacramento laundry room. Technician arrived in under an hour, cleared the pump filter, and tested three full cycles before leaving. Outstanding service.
LG washer displayed an OE error code every other load in Pleasanton. The drain pump had a sock stuck in the impeller. Technician cleared it out and ran diagnostics — zero errors since the repair.
Verified reviews from homeowners across San Francisco and Bay Area
“Sub-Zero 36-inch built-in with a noisy compressor. Compressor mounts were worn causing vibration. Mounts replaced and compressor serviced for $295. Fridge is quiet and cooling perfectly. Sub-Zero expertise is rare and valuable.”
Tammy B.
Refrigerator Repair
Palo Alto, CA
“Our Samsung dishwasher was leaking from the bottom. The technician found a loose hose clamp on the circulation pump. It was a simple fix for $120 — I really appreciated the honesty since they could have sold me a new pump. The dishwasher has been leak-free since. Trustworthy company.”
Yuki N.
Dishwasher Repair
San Mateo, CA
“KitchenAid built-in refrigerator was forming puddles underneath. Clogged defrost drain was sending water out the bottom instead of into the drain pan. The tech cleared the drain, added a drain heater clip to prevent recurrence, and cleaned the drain pan. $175 for a fix that eliminated a really annoying problem.”
Alicia R.
Refrigerator Repair
Palo Alto, CA
“Our LG French door refrigerator stopped cooling overnight. With a fridge full of food, we needed emergency service. The tech came same-day, diagnosed a failed compressor relay, and had it running in under an hour. He also told us about LG's compressor warranty which covered the part. Outstanding service.”
Anthony R.
Refrigerator Repair
Sunnyvale, CA
“Our 20-year-old Sub-Zero had a warm refrigerator section. The tech was clearly experienced with Sub-Zero — he diagnosed a failing evaporator fan and weak door gaskets. Replaced both, cleaned the condenser, and the unit is performing like new. $520 for a repair on a unit worth $15K+ to replace. No-brainer.”
Richard Y.
Refrigerator Repair
Cupertino, CA
“Called EasyBear on a Sunday morning when my Samsung fridge stopped cooling. A technician arrived by early afternoon, diagnosed a failed evaporator fan motor, and had it replaced within 90 minutes. Food saved, stress gone. The $265 was absolutely worth it.”
Karen L.
Refrigerator Repair
San Francisco, CA
“Whirlpool fridge compressor running non-stop. Dirty condenser coils were the culprit. Thorough cleaning for $95 service fee. Compressor now cycles normally and energy bill dropped.”
Dave K.
Refrigerator Repair
Daly City, CA
“The technician arrived within 2 hours of my call and diagnosed the issue immediately — a faulty defrost timer causing ice buildup. He had the part on his truck and fixed it in under an hour. My fridge has been running perfectly for 3 months now. Very reasonable price at $275.”
Sarah M.
Refrigerator Repair
San Francisco, CA
“GE upright freezer was running but not getting below 25°F. The evaporator fan motor was failing. Tech replaced it and also checked the defrost system which was still working fine. $210 total and the freezer is back to 0°F. Saved about $800 in frozen food that would have spoiled. Worth every penny.”
Raymond G.
Freezer Repair
San Francisco, CA
“Our chest freezer stopped freezing and we had hundreds of dollars of meat inside. Called at 8am and the tech arrived by 10:30am. Faulty thermostat was the culprit — replaced in 30 minutes. Saved all our food! Cost was $175. Can't thank them enough for the fast response.”
Amanda J.
Freezer Repair
Concord, CA
“Finding someone experienced with Sub-Zero was tough until I found this company. Our 15-year-old Sub-Zero was running constantly and not cooling. The tech cleaned the condenser, replaced the fan motor, and it's been running like new. Worth every penny of the $450 repair — a new Sub-Zero is $12,000+.”
James C.
Refrigerator Repair
Berkeley, CA
“The notorious Samsung ice maker problem struck our French door fridge. The tech was very familiar with this specific issue, performed the recommended fix including defrosting the evaporator and installing a new ice maker kit. It's been 6 weeks and still working great. $350 well spent.”
Wei Z.
Refrigerator Repair
Cupertino, CA