Gas burner clicking nonstop? We clean and repair igniters, spark modules, and switches. Same-day service, 90-day warranty. Average repair cost: $80–$200. Some causes are DIY-fixable — see below.
Gas Stove continuous clicking repair typically costs $80 to $200. Some causes are DIY-fixable, but professional diagnosis is recommended if the problem persists. Most repairs are completed in 45 min-1 hour with a free diagnostic visit.
Continuous gas stove clicking in Sausalito is heavily driven by the town's persistent fog and salt-laden marine air. Hillside cottages from 1955 have compact kitchens where cooking steam compounds with coastal humidity to keep igniter switches perpetually damp. Salt deposits from marine air add a highly conductive element. With only 7,000 residents and 2 local repair providers, clicking service comes primarily from San Rafael or Mill Valley.
Sausalito's waterfront location creates the most aggressive clicking environment in Marin County. Persistent fog, high humidity, and direct salt-air exposure keep igniters perpetually damp and salt-contaminated. Marin MWD soft water at 35 TDS is beneficial for boil-over residue, but the salt-and-moisture environment overwhelms this advantage.
Moisture in igniter switch
Food debris in burner cap
Misaligned burner cap
Faulty spark module
Stuck igniter switch
Bay Area coastal humidity and fog create condensation on igniter switch contacts, completing the circuit that triggers continuous sparking. The clicking typically starts overnight or on foggy mornings and may stop as the kitchen warms. Boil-over liquid that seeps into the switch is another common trigger.
Cost: $60–$130 | Time: 30-60 minutes
Food particles and boil-over residue create conductive paths across the spark gap or switch contacts. The system interprets this as a continuous signal to spark. In Bay Area kitchens with frequent multi-burner cooking, spills onto the cooktop surface are a daily occurrence.
Cost: $40–$80 | Time: 20-40 minutes
The spark module's internal circuitry can short from moisture, creating a stuck-on condition. PG&E power surges can damage the module's timing circuit, causing continuous sparking rather than on-demand pulses. When the module fails, all burners click simultaneously.
Cost: $100–$200 | Time: 45-75 minutes
The wiring between the spark module and individual igniters can short from boil-over liquid, rodent damage, or heat degradation. A short creates a continuous signal to the module. The clicking may affect only certain burners or all of them depending on where the short occurs.
Cost: $80–$180 | Time: 45-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $80–$200 |
| Repair time | 45 min-1 hour |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
Clicking repair in Sausalito costs $80 to $200. With 2 local providers, San Rafael services handle most calls. Corrosion-resistant component upgrades are recommended.
In Sausalito, salt-laden marine air and persistent fog deposit corrosive moisture on metal surfaces and electronics. This can affect your appliance's thermocouple: salt deposits on the thermocouple tip create an insulating layer, causing flame-sensing failures and gas shutoff Clean the thermocouple tip with fine emery cloth annually; never use water or cleaning solutions
In Sausalito, sustained relative humidity above 60% promotes mold growth, condensation on cold surfaces, and accelerated corrosion. This can affect your appliance's igniter electrode: moisture on the ceramic igniter insulator allows the spark to track down the side instead of jumping to the burner, preventing ignition Dry the electrode and surrounding area if the burner fails to light; a hair dryer on low can remove trapped moisture
In Sausalito, very low mineral content (<60 ppm tds) or sodium-softened water causes over-sudsing, rubber swelling, and reduced detergent rinsing. This can affect your appliance's oven interior: soft water steam clean cycles leave a sodium residue film on interior surfaces that can smoke during subsequent cooking Use distilled water for steam clean functions; wipe interior with a damp cloth after the cycle completes
Free diagnostic visit for continuous clicking issues. Same-day appointments available in Sausalito.
Book Free DiagnosticReviewed by Robert Aguilar, Field Service Manager & Technical Reviewer