Gas burner clicking nonstop? We clean and repair igniters, spark modules, and switches. Same-day service, 90-day warranty. Average repair cost: $80–$200. Some causes are DIY-fixable — see below.
Gas Stove continuous clicking repair typically costs $80 to $200. Some causes are DIY-fixable, but professional diagnosis is recommended if the problem persists. Most repairs are completed in 45 min-1 hour with a free diagnostic visit.
Continuous clicking from a gas stove in Campbell is typically caused by mineral residue from SJWC water at 250 TDS depositing on igniter components. Bungalow and ranch kitchens from 1962 with 60+ years of cooking accumulate debris near igniters. The compact bungalow kitchens concentrate cooking steam and grease around the stovetop. With 43,000 residents and 6 local repair providers, clicking is efficiently resolved.
Campbell's compact bungalow kitchens concentrate cooking steam and grease around the stovetop more than open-plan kitchens. SJWC water at 250 TDS deposits minerals from boil-overs. The combination of concentrated grease, mineral deposits, and limited ventilation creates the full spectrum of clicking triggers.
Moisture in igniter switch
Food debris in burner cap
Misaligned burner cap
Faulty spark module
Stuck igniter switch
Bay Area coastal humidity and fog create condensation on igniter switch contacts, completing the circuit that triggers continuous sparking. The clicking typically starts overnight or on foggy mornings and may stop as the kitchen warms. Boil-over liquid that seeps into the switch is another common trigger.
Cost: $60–$130 | Time: 30-60 minutes
Food particles and boil-over residue create conductive paths across the spark gap or switch contacts. The system interprets this as a continuous signal to spark. In Bay Area kitchens with frequent multi-burner cooking, spills onto the cooktop surface are a daily occurrence.
Cost: $40–$80 | Time: 20-40 minutes
The spark module's internal circuitry can short from moisture, creating a stuck-on condition. PG&E power surges can damage the module's timing circuit, causing continuous sparking rather than on-demand pulses. When the module fails, all burners click simultaneously.
Cost: $100–$200 | Time: 45-75 minutes
The wiring between the spark module and individual igniters can short from boil-over liquid, rodent damage, or heat degradation. A short creates a continuous signal to the module. The clicking may affect only certain burners or all of them depending on where the short occurs.
Cost: $80–$180 | Time: 45-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $80–$200 |
| Repair time | 45 min-1 hour |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
Clicking repair in Campbell costs $80 to $200. The 6 local providers plus the San Jose market handle this routine service.
In Campbell, wide day-night temperature swings (30f+ delta) stress thermal expansion joints, thermostat cycling, and sealed-system pressures. This can affect your appliance's flex gas connector: thermal cycling fatigues the corrugated stainless steel gas connector, increasing the risk of micro-cracks at the flare fitting Have the gas connector inspected during annual service; replace corrugated connectors every 10 years proactively
Free diagnostic visit for continuous clicking issues. Same-day appointments available in Campbell.
Book Free DiagnosticReviewed by Diana Kowalski, Laundry Systems Specialist