Want a regional phone & address? Pick your area.
Viking·Oven/Rangehigh severity
Viking Error Code F02
RTD temperature sensor fault
Common Causes
- 1RTD sensor open/short circuit
- 2Wiring break
- 3Connector corrosion
Disconnect power before accessing RTD sensor. On dual-fuel Viking ranges, gas supply must also be shut off before pulling the unit from the wall.
Step-by-Step Troubleshooting
- 1
Disconnect power and access RTD sensor behind rear oven panel
- 2
Measure RTD resistance at room temp — Viking spec is 1080-1090 ohms at 72F
- 3
Inspect sensor wire routing for heat damage near ProFlow convection fan area
- 4
Check harness plug at control board for corrosion or carbon deposits
- 5
Replace sensor if resistance deviates more than 5% from spec
Pro Diagnostic Tip
Viking RTD sensors drift with age — if reading is within spec at room temp but F02 fires during preheat, test at 200F; resistance should be ~1400 ohms
You Might Also Notice
- •Oven does not heat or overheats
- •Temperature fluctuates wildly during bake cycle
- •ProFlow convection produces uneven results
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$200–$450
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
PA010042 (RTD temperature sensor)PB040019 (sensor harness)
Do You Have the Right Tools?
Combustion analyzer ($300), igniter tester ($120), temperature calibrator ($150), and gas pressure manometer. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
Gas ovens involve live gas lines — a loose connection creates explosion and carbon monoxide risk. Electric ovens run on 240V circuits. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Get Professional Help Now
Error code F02 is a high-severity issue that can cause further damage to your oven/range if left unresolved. A licensed technician can diagnose and fix it the same day.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Viking error code F02 mean?
Viking error code F02 indicates: RTD temperature sensor fault. This is a high-severity issue affecting your oven/range.
How do I fix Viking error code F02?
Disconnect power and access RTD sensor behind rear oven panel Then, Measure RTD resistance at room temp — Viking spec is 1080-1090 ohms at 72F Then, Inspect sensor wire routing for heat damage near ProFlow convection fan area There are 2 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my oven/range has error F02?
Besides the error code on the display, common signs include: Oven does not heat or overheats; Temperature fluctuates wildly during bake cycle; ProFlow convection produces uneven results. If you notice any of these symptoms, check your oven/range's display panel for error code F02.
How much does it cost to fix Viking F02?
Repair costs for Viking F02 typically range from $200 to $450 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.