Want a regional phone & address? Pick your area.
Kenmore·Washermedium severity
Kenmore Error Code F20
No water detected entering machine
Common Causes
- 1Water supply valves turned off
- 2Inlet screens clogged
- 3Inlet hoses kinked
- 4Pressure switch hose disconnected
Step-by-Step Troubleshooting
- 1
Verify both hot and cold supply valves are open
- 2
Remove inlet hoses and clean the mesh screens at the valve
- 3
Check for kinks in the supply hoses
- 4
Inspect the pressure switch hose at the tub for disconnect
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$75–$225
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
Water inlet valvePressure switch
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Check water supply valves
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F20 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Kenmore error code F20 mean?
Kenmore error code F20 indicates: No water detected entering machine. This is a medium-severity issue affecting your washer.
How do I fix Kenmore error code F20?
Verify both hot and cold supply valves are open Then, Remove inlet hoses and clean the mesh screens at the valve Then, Check for kinks in the supply hoses There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How much does it cost to fix Kenmore F20?
Repair costs for Kenmore F20 typically range from $75 to $225 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.