LG Oven Won't Turn Off — DIY or Pro?
An LG oven stuck on is a fire hazard — kill the circuit breaker immediately, and close the gas valve on a gas model. The board's relay welded shut by a surge (control board EBR86433605 on LRE/LSE series) is the usual cause, followed by a temperature sensor shorted to a false 0 ohms, or a stuck touchpad key. An F1 or…
Safety and the right tools#
First, kill power at the breaker — on hardwired LG built-ins that's the only safe disconnect — and on a gas model close the gas valve; if you ever smell gas, leave and call the utility. LG panels use Torx fasteners rather than Phillips, so a set of T15, T20, and T25 drivers saves you stripped screws, and a multimeter is needed for the resistance checks.
The main causes#
- A welded control-board relay (most common). LG boards (EBR86433605 on the LRE/LSE series) use mechanical relays that can weld shut from a power surge, leaving the element powered no matter the command — a fire hazard, so disconnect power at once.
- A shorted temperature sensor. A sensor shorted to ground reads a false 0 ohms; the board reads that as extremely cold and calls for maximum heat indefinitely.
- A stuck touchpad key. Moisture or age can stick an LG touchpad key, which then sends a continuous heat command.
Do You Have the Right Tools?
Combustion analyzer ($300), igniter tester ($120), temperature calibrator ($150), and gas pressure manometer. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Reading the codes and testing#
Before you cut power, note the error code: F1 or F3 indicates a sensor fault, and F9 and F11 are the other codes commonly seen with this symptom. With power off, measure the temperature sensor's resistance — near 0 ohms confirms a short, and it's replaced before power goes back on. The parts most often replaced here are the control board (EBR86433605), the temperature sensor (MEA36701801), and the touchpad (EBR64624906); verify your serial-plate model before ordering, since LG part numbers shift between production years.
When to call a pro — and a holiday note#
If you can't confirm the fault, or the oven is hardwired, leave it powered off for a technician rather than restoring power to a possibly live element. As a rule of thumb, if the repair runs less than 50% of a new oven's cost and the unit is under 8 to 10 years old, repairing is the better call — and it's worth sorting before the oven carries heavy holiday baking. Book an EasyBear technician, who carries LG-specific tools and OEM parts, and keep the oven off until it's fixed.
Senior Appliance Repair Technician · 15 years experience
EPA-certified technician with 15 years of experience specializing in refrigerator and cooling system repairs.


