How to Reset an Amana Dishwasher

Quick Answer: Resetting a Amana Dishwasher#

The entire reset on an Amana dishwasher is a power interruption: switch it off at the breaker or the cabinet cutoff beneath the sink, pause, and restore it. That clears a console that has frozen or a wash that quit after a brownout. It does nothing for a machine failing on its latch, float, or drain pump, because those faults are mechanical rather than confused firmware.

How to Reset a Amana Dishwasher (Step by Step)#

1. Amana is the value tier of the Whirlpool platform, so most Amana dishwashers have no Control Lock pad — the power cycle at the breaker or under-sink switch is essentially the whole reset.
2. Leave the power off for one minute to clear the basic control board, then switch it back on.
3. To end a stuck cycle, press and hold the Start/Resume pad for three seconds; the tub drains and the simple indicator lights return to ready.

Amana Dishwasher Model Variations#

Front-loading Amana consoles keep the Start/Resume key right on the visible panel, so cancelling and emptying a load takes only that single button. Because these units sit at the budget end of the lineup, nearly every trim skips a keypad lock entirely — there is no hidden combination to release before the machine responds. Should a fault reading outlive the interruption, treat it as a Whirlpool-platform code, since the two brands run one shared board and the same diagnostic table.

When a Reset Doesn't Fix Your Amana Dishwasher#

When cutting the power changes nothing, the trouble is rarely software on this class of board. A wash that keeps quitting usually traces to a door strike that no longer seats or a line that has backed up, so inspect the catch and clear the pump and hose first. If a reading stays lit, match it against our Amana error-code guide, then walk the dishwasher-not-draining, will-not-start, and stops-mid-cycle symptom pages in order for the components most likely at fault.

Need Professional Help?#

• dishwasher repair service
• dishwasher repair cost guide

If a power-cycle and the checks above do not bring your Amana dishwasher back, book a free diagnostic and an EasyBear technician will take it from there.

Amana Dishwasher Reset FAQ#

How do I reset an Amana dishwasher?

Cut power at the breaker or the switch beneath the sink, wait about a minute so the board fully discharges, then bring it back. For a load that jammed partway, a long press on Start/Resume empties the tub and returns the panel to standby.

How do I cancel a cycle on an Amana dishwasher?

Hold the Start/Resume key down until the pump kicks in — roughly a three-count. Amana leans on that one key for cancelling because its value consoles rarely carry a separate cancel button.

Why does my Amana dishwasher stop mid-cycle?

A repeated halt partway through usually means the door catch is dropping contact or waste water cannot clear, not a glitch in the electronics. Confirm the latch clicks shut and the drain runs freely before you suspect the controller.

Why will my Amana dishwasher not drain?

Water left standing after a restart points to a clogged filter, a pinched hose, or a tired pump rather than the board. Pull and rinse the strainer at the bottom of the tub and straighten the hose before condemning the motor.

Do Amana dishwashers have a control lock?

Most budget Amana models leave the lock feature switched off, so there is no keypad to release — the power interruption plus the Start/Resume drain covers everything. A handful of upper trims include one, freed with a short hold of that same key.