Whirlpool WRX735 Refrigerator — Problems & Repair

The WRX735 is a 25 cu. ft. Whirlpool 4-door French-door with a dual-cooling system, FreshFlow produce preserver, and Measured Fill dispensing. Its faults center on the ice maker, cooling balance, and dispenser. Here is the ranked data and how to triage it.

Models this covers#

• WRX735SDHZ
• WRX735SDBM
• WRX735SDHV
• WRX735SDHB

Spec at a glance#

Ranked failures#

1. Ice-maker harvest fingers jam in the flexing tray — 18%. The maker will not release cubes and stalls.
2. FreshFlow air-filter compartment warps — 15%. The compartment distorts and the filter no longer seats.
3. Dual-evaporator system fault — 14%. One compartment runs off-temperature as cooling falls out of balance.
4. Measured Fill dispenser solenoid sticks — 12%. The measured pour overshoots or will not stop.
5. Defrost drain line kinks — 10%. Water leaks from the center channel as the drain routing pinches.

Error codes and reset#

• Error CF — cooling / communication fault

For odd behavior, a power reset — unplug for 60 seconds, then restore power — clears many transient issues.

What to check before you book#

If ice has stopped, inspect the flexing tray and harvest fingers for a jam, and confirm the water supply is on. If one compartment is warm while the other is fine, the dual-evaporator balance is the likely cause rather than the compressor. For Measured Fill overshooting, clean around the dispenser solenoid before assuming it has failed. A center-channel leak points at a kinked or iced defrost drain — clear it with warm water. Vacuum the condenser and give the unit a day, since a dusty condenser mimics several cooling faults. Note the matching failure and book the repair.

Fix or replace?#

The ice maker, filter compartment, and dispenser solenoid are moderate-cost parts, so repair is the sensible choice while the sealed system is healthy and the unit is under about a decade old, keeping the fix under half a new fridge's price. A compressor failure on an older WRX735 is the clear replace case.

Keeping it healthy#

• Vacuum the condenser coils twice a year.
• Clear the defrost drain line with warm water if you see center-channel water.
• Replace the water filter on schedule to protect the ice maker.

Related guides#

• Whirlpool refrigerator not cooling
• Whirlpool refrigerator leaking
• Whirlpool refrigerator ice maker not making ice

Getting the most out of your WRX735#

The WRX735's strengths are its 4-door layout and dual-cooling system, and keeping both healthy is mostly about airflow and clean water. Vacuum the condenser coils twice a year so the compressor is not forced to run long — that single habit prevents a share of the cooling and fan complaints. Replace the water filter on schedule, since a starved supply drives the ice-maker harvest jams that top this model's failure list. In humid months, watch the defrost drain and the ice tray for icing, and clear the center-channel drain with warm water at the first sign of a leak. Because the two evaporators share the cooling load, keep the vents between compartments clear so neither side is forced off-temperature. With that care, the WRX735 holds even cooling for years, and its common faults stay moderate repairs rather than reasons to replace the whole refrigerator.

Recall status#

No active recalls on the WRX735 series as of 2026-05-28. Verify at cpsc.gov.

Book a Whirlpool WRX735 repair at /book — upfront pricing and common Whirlpool parts stocked.