F1 E3 on a combination wall oven
Maytag's code list ties F1 E3 to a possible problem with the microwave appliance manager, or the wiring associated with it. That name points to the control that runs the microwave section, which matters most on a combination wall oven, where a microwave sits above a conventional oven in one cabinet. Restart the unit once from its breaker. If F1 E3 returns, stop using the microwave section and book a professional; whether the oven below can still be used safely is a question for the technician, not for guesswork.
Error codes
Reference| Code | Meaning |
|---|---|
| F1 E3 | There may be a problem with the Microwave Appliance Manager, or the associated wiring. |
What F1 E3 can look like
- The microwave section will not start — Keys for the microwave are ignored, or the cycle cancels at once. The display may show F1 E3 instead.
- The code during microwave cooking — Heating stops partway through and the code appears.
- The lower oven still responds — On some combination units the oven carries on working. Note it, but do not rely on it until the fault is diagnosed.
- A blank or frozen display — The control panel stops responding to any key.
- A buzzing or burning smell from the upper section — Switch off at the breaker straight away.
Ranked causes of F1 E3
- The microwave appliance manager — First: the code names this control directly. In a combination unit it lives close to the heat of the oven below.
- A loose or damaged connector — Second: the wiring between the microwave control and the rest of the unit can work loose.
- A fault elsewhere in the microwave section — Third: a failing part in the microwave circuit can upset its control.
- A supply problem — Fourth: a poor connection where power enters the cabinet.
Checks for F1 E3, in order
- Note which section fails — The microwave, the oven, or both.
- Restart once — Switch the unit off at its breaker for a few minutes, then back on.
- Try a short microwave run — Only with a cup of water inside; never run a microwave empty.
- Watch for the code — Note whether F1 E3 returns and when.
- Smell and listen — Any buzzing, arcing sound or burning smell means stopping.
Owner steps for F1 E3
- Power-cycle at the breaker — Combination units are usually hard-wired, so the breaker is the only reset.
About 5 min
- Run a brief microwave test — Heat a cup of water for a short time and watch the display.
Tools: microwave-safe cupAbout 2 min
- Stop if the code returns — Leave the microwave section unused until it is checked.
Tools: ::
- Record the details — Which section failed, when, and what the display showed.
Tools: notepadAbout 3 min
- Leave the cabinet closed — Microwave circuits store a dangerous charge, so all testing is for a professional.
Tools: ::
Safety with a microwave fault
Never remove the cover or trim of a combination unit: the microwave section contains a high-voltage capacitor that can hold a lethal charge long after the power is off. Do not run the microwave empty, and stop at once if you see sparks or hear arcing. If either section smells of burning or heats when nothing is set, switch the unit off at its breaker and leave it off.
When F1 E3 needs a professional
Call if F1 E3 returns after a restart, or at once if there were sparks, arcing or a burning smell. A professional checks the microwave appliance manager, its wiring and the microwave circuit, and confirms whether the oven section is safe to use in the meantime.
Appliances covered
This page covers Maytag combination wall ovens and other Maytag ovens whose code list includes F1 E3. It does not cover countertop or over-the-range microwaves, cooktops or other brands. No model-specific F1 E3 page exists yet; layouts differ, so check your model's documentation.

