What 1c2c is saying
Jenn-Air's list ties 1c2c to the user interface keypad or its associated wiring. The interface sits close to the oven's heat, especially on wall ovens where warm air leaves through a vent near the control panel, and years of heat take a toll on the panel and its cable. Restart the oven once; if 1c2c reappears, especially after long bakes or a self-clean, have the interface and its wiring checked.
Error codes
Reference| Code | Meaning |
|---|---|
| 1c2c | There may be a problem with the User Interface/Keypad, or the associated wiring. |
When 1c2c tends to appear
- After a self-clean cycle — The highest temperatures the oven reaches also heat the control area.
- Late in a long bake — The interface is warmest after hours of cooking, which is when a weak part gives up.
- With pads that stop working when the oven is hot — Heat-sensitive faults ease as the oven cools down again.
- With a discoloured area near the panel — Heat marks suggest the control area runs hotter than it should.
- With a clock that resets during cooking — A connection affected by heat can briefly interrupt the interface.
- Pads that respond again the next morning — A fault that clears once everything is cold is typical of heat-sensitive damage.
Causes, ranked
- Heat damage to the interface — First: the interface's electronics and membrane age faster in heat, and a code after hot cycles points here.
- A cable or connector affected by heat — Second: heat can harden insulation and loosen connectors behind the panel.
- A blocked oven vent — Third: items covering the vent, or a cabinet that traps heat, raise the temperature around the controls.
- A control board fault — Fourth: the control that reads the interface can also fail.
Order of checks
- Note when 1c2c appears — Hot oven, after self-clean or at switch-on.
- Check the oven vent — Make sure nothing covers it.
- Restart once the oven has cooled — Breaker off for several minutes, then on.
- Test the pads cold and warm — Pads that fail only when hot point to heat damage.
- Look for heat marks around the panel — Discoloured or warped trim near the control suggests the area runs hotter than intended.
Owner steps
- Let the oven cool — Leave it off until the control area is cool to the touch.
About 45 min
- Clear the vent — Remove anything resting on or blocking the vent.
About 2 min
- Restart from the breaker — Switch off, wait several minutes, switch on.
About 5 min
- Test the pads at room temperature — Note any that do not respond.
About 5 min
- Stop at the panel — The interface and its wiring are checked with the panel removed and the power off, by a professional.
Tools: ::
Heat and electrical safety
The control area can be hot after long cooking or a self-clean, so let it cool before touching it. Turn the oven off at the breaker before inspecting anything, and do not remove the control panel: the electronics behind it can hold a charge. If the oven heats when nothing is set, keep the breaker off.
When 1c2c needs a professional
Ask for a professional if 1c2c returns after a restart, if pads fail when the oven is hot, or if there are heat marks near the control. They can replace a heat-damaged interface or cable and check whether the oven's venting is sending too much heat toward the controls. If the oven sits in a tall cabinet, mention it, so the visit can include a look at whether the cabinet traps heat around the controls.
Neighbouring oven codes
Coverage of 1c2c
This reading covers Jenn-Air wall ovens and ranges with an electronic interface that list 1c2c. It does not cover Jenn-Air microwaves or cooktops, or other brands. No model-specific 1c2c page exists yet; vent and interface layouts vary, so check the documentation for your model.

