How to Reset an Amana Microwave

The minute is the part people cut short: a board holds its state on residual charge for a few seconds, so a quick flick of the breaker hands back the condition the microwave was already in.

EasyBear is an independent appliance repair company. We are not affiliated with or authorized by Amana.

How to Reset a Amana Microwave (Step by Step)#

1. Power unit down by turning off the circuit breaker(s) for one (1) minute.
2. Power unit up by turning on the circuit breaker(s).

The documented route is the breaker, not a plug. An over-the-range unit sits fixed above the range with its supply behind cabinetry, so the panel is the dependable way to cut power to it.

What a Amana Microwave Reset Does and Doesn't Clear#

The power-down clears whatever the control was holding: a display frozen partway through a cycle, a keypad that stopped registering presses, a unit that beeps but never starts. Those are held states rather than damage, and none survives a board that has lost its supply.

What it does not touch is anything physical inside the cavity: a microwave that runs its full time and hands back cold food has a heating fault, and rebooting will not change that.

You can tell it worked when the display returns and accepts a time, every keypad press registers, and a short run warms a cup of water.

When a Reset Doesn't Fix Your Amana Microwave#

If the same behaviour is back before you have left the kitchen, stop repeating the power cycle — a second pass does what the first did. Read whatever the display reports against our Amana error-code guide: the code points past the control to the part behind it.

From there it is a parts question. Our microwave repair service page covers what a visit involves, and the microwave repair cost guide sets expectations first.

When the reset has not held, book a free diagnostic and an EasyBear technician will trace it from the panel inward.

Amana Microwave Reset FAQ#

How do you reset a Amana microwave?

Switch off the circuit breaker feeding it, leave it off for one minute, then switch it back on. There is no separate button sequence documented for this reset.

How long should a Amana microwave stay unplugged for a reset to work?

One minute without power, achieved at the breaker rather than the cord — long enough for the control to drop the state it was holding instead of resuming it.

Does resetting a Amana microwave erase its settings?

It clears what the control holds at that moment — in practice the clock and anything queued. Re-enter the time once power is back.

Why does my microwave keep showing the same fault after a reset?

Because the condition producing it has not gone anywhere. A stuck state does not return; one that does is being re-detected, which points at hardware rather than memory.

What should I do if resetting the microwave does not clear the problem?

Write down what the display shows and what the unit will and will not do, then check that against the Amana error-code guide before booking. Those details shorten the diagnosis.

Is it safe to reset a Amana microwave at the breaker?

Yes — cutting and restoring power at the panel is the intended way to do it to a fixed appliance. Do not open the case, though: the inside of a microwave stores electrical energy and is not owner-serviceable space.