How to Replace LG Stove Drip Pans
Swapping the drip pans and plug-in coil elements on an LG coil-top electric range is a tool-free, 15-20 minute beginner job that restores both looks and even heating. Match each new pan to its 6-inch or 8-inch element and the whole set drops in by hand.
Over the years the chrome or porcelain pans warp and cake with baked-on carbon that cleaning cannot lift, and worn elements start glowing unevenly. Replacing them together brings the cooktop back. This applies to LG freestanding ranges with plug-in coil burners, not smooth glass cooktops, and LG uses standard 6-inch and 8-inch pans whose center opening must clear the element receptacle.
Before you start#
| Category | What you need |
|---|---|
| Tools | None; plug-in elements and drip pans are a tool-free swap |
| Parts | Drip pan set (two 6-inch and two 8-inch), plus replacement elements if worn |
| Time and level | 15-20 minutes, Beginner |
Safety warning: Turn off all burner controls and disconnect the range from the outlet or turn off the breaker. Allow 30 minutes for cooling after last use. Never pull a hot element from its receptacle.
Do You Have the Right Tools?
Combustion analyzer ($300), igniter tester ($120), temperature calibrator ($150), and gas pressure manometer. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Step-by-step#
1 - Confirm the sizes. LG coil ranges typically pair two 6-inch small burners rated near 1250 to 1500 watts with two 8-inch large burners rated near 2100 to 2600 watts. Note your layout so the new pans and any elements match.
2 - Pull the elements. Grip the outer coil, lift its edge slightly, and draw it straight toward you so the two terminal prongs slide out of the receptacle. If the prongs resist, rock the element gently side to side while pulling, and never bend the coil.
3 - Lift out the old pans. With the element out, raise the drip pan straight up; it sits in the well by gravity alone. Tilt it to clear the receptacle block that passes through the rear notch.
4 - Clean the wells. Wipe the well beneath each pan with warm soapy water, and use a non-abrasive cleaner on baked-on deposits. Inspect the receptacle block contacts, where light discoloration is fine but heavy black carbon signals arcing that may need a new receptacle.
5 - Inspect the elements. Before reusing an element, look for bright hot spots, blistered coating, or uneven glow, all of which mean it should be replaced. A healthy element glows uniformly red-orange across the full coil on HIGH.
6 - Drop in the new pans. Set each new pan into its well with the rear notch around the receptacle block so the rim sits flat and does not rock. Chrome pans clean easier; porcelain resists discoloration longer.
7 - Refit or replace the elements. Line the terminal prongs up with the receptacle and push straight in until they seat fully, so the element rests level in the pan on its front support without touching the pan surface.
8 - Test each burner. Restore power, set each burner to HIGH, and confirm the coil glows evenly while the pan stays cool, since the pan reflects heat rather than absorbing it. A faint odor on first use from manufacturing oils is normal.
When to call a professional#
EasyBear technicians serving Sacramento and the Bay Area carry LG-specific diagnostic tools and replacement parts on every service call.
- The receptacle block shows melting, arcing, or heavy carbon, which means working with 240V wiring under the cooktop.
- Several elements fail together, pointing to a switch or harness fault rather than the elements.
- The cooktop surface under the pans is warped or corroded and no longer seats a pan flat.
Safety First — Know the Risks
Gas ovens involve live gas lines — a loose connection creates explosion and carbon monoxide risk. Electric ovens run on 240V circuits. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Appliance Repair Technician · 8 years experience
Experienced technician with 8 years specializing in dishwasher repairs and European appliance brands including Bosch and Thermador.
