Frigidaire FGID2466 Dishwasher Guide

The FGID2466 is a mid-range Gallery built-in with the OrbitClean four-arm wash system and widely stocked parts, so most faults are affordable to fix. Below are the covered models, the recurring problems, the codes, the wear parts, and a repair-or-replace line.

Models covered#

Four variants built from 2015 to 2023 share one platform:

Common problems for this model#

The hub crack and the drain pump together are about 34% of all FGID2466 visits, and both are stocked, straightforward repairs.

Error codes#

The Gallery panel reports faults in an i-code family — i10, i20, i30, i40, i50, and i60 — each pointing at a specific subsystem. For a code not listed, cut power for 60 seconds and restore it before assuming a hardware failure; a returning code needs a real diagnosis.

Wear parts#

Verify the part number against your exact model before ordering:

Recall status#

There are no active recalls on the Frigidaire FGID2466 series as of 2026-05-28. Check your model against the Consumer Product Safety Commission list at cpsc.gov periodically.

Repair or replace?#

Gallery dishwashers are solid mid-range units with cheap, available parts, so repair usually wins. The rule: under 10 years old with a fix below 50% of a comparable new dishwasher, repair. After 10 years, tally recent costs — once repairs over the last 2-3 years exceed 40% of replacement, a new unit with warranty is the better value.

Maintenance that prevents failures#

The signature hub crack is easier to catch than to fix, so build a quick quarterly check into your routine. Inspect the OrbitClean center hub for hairline cracks every quarter, and clear the spray-arm jets of mineral scale at the same time. Clean the drain filter assembly every two weeks, and run an empty hot cycle with dishwasher cleaner once a month. Scrape plates but do not pre-rinse — the DishSense sensor needs some residue to set the cycle correctly.

FAQ#

What are the most common Frigidaire FGID2466 problems?#

The top two are the OrbitClean spray-arm center hub cracking and the drain pump motor failing, together roughly 34% of service calls. Others include DishSense soil-sensor miscalibration and MaxBoost heater burnout; watch for i10, i20, or i30 on the display, each flagging a specific part.

How long should an FGID2466 dishwasher last?#

With regular filter cleaning and a quarterly hub check, expect about 10-13 years of service. The most frequent failure — the cracked spray-arm hub — is a known, repairable part, not a sign the machine is worn out.

Why is water standing in the bottom after a cycle?#

Standing water almost always means the drain pump motor (part 154736201) has failed or the drain filter is clogged. Clean the filter first; if the tub still will not drain, the pump is the usual culprit and a stocked replacement.

Book a Frigidaire FGID2466 repair#

We service Frigidaire dishwashers across Sacramento and the Bay Area, and our techs stock the common FGID2466 parts, so most repairs finish in a single visit. Book your repair for same-day or next-day service, upfront pricing, and a 90-day parts-and-labor warranty.