Frigidaire FFCD2413 Entry Dishwasher Guide

Use this as your FFCD2413 (Entry Dishwasher) reference: shared model numbers, ranked failures with the parts behind them, diagnostic codes, recall notes, and an honest fix-versus-replace framework. Every figure and part number below traces back to the FFCD2413 (Entry Dishwasher) record, not a generic dishwasher template.

FFCD2413 (Entry Dishwasher) at a glance#

Model numbers on this platform: FFCD2413US, FFCD2418US, FFCD2413UW, FFCD2413UB. If your tag starts with the same FFCD2413 (Entry Dishwasher) prefix, this guide still applies.

Common problems on the FFCD2413 (Entry Dishwasher)#

These are the faults that account for the bulk of FFCD2413 (Entry Dishwasher) service calls:

Heating element burnout. What you'll see: dishes not getting dry, element visible through bottom of tub. Expect it in near 20% of the repairs logged on this platform. Catch it early and the repair usually stays contained.

Drain pump impeller jam. In the field: food debris or glass shards blocking pump. It accounts for roughly 18% of FFCD2413 (Entry Dishwasher) service calls. Diagnosing it promptly keeps the fix small.

Water inlet valve solenoid failure. Symptom: dishwasher will not fill. On the FFCD2413 (Entry Dishwasher) it lands at about 14% of repair visits, and the water inlet valve solenoid is the component to check first. Catching it early keeps the repair small.

Door latch failure. The tell — dishwasher starts then stops immediately. Expect it in near 10% of the repairs logged on this platform, and the first check belongs on the door latch. It is easier to resolve before the fault spreads.

Spray arm bearing wear. What you'll see: water not reaching upper rack. It accounts for roughly 8% of FFCD2413 (Entry Dishwasher) service calls, and the diagnosis starts at the spray arm bearing. A clean diagnosis here avoids a bigger teardown.

How this model reports faults#

The Frigidaire FFCD2413 (Entry Dishwasher) series may display the following error codes on its control panel or digital display. A 60-second power cut at the breaker clears many transient faults; if the behavior returns, book a diagnosis.

Parts that fail most#

These are the FFCD2413 (Entry Dishwasher) parts we replace most; verify the number on your data plate before buying.

Recall status#

The FFCD2413 (Entry Dishwasher) carries no open recalls as of 2026-05-28. Re-check cpsc.gov with your model number now and then — the CPSC will email alerts if that changes.

Repair or replace?#

The FFCD2413 (Entry Dishwasher) math is simple: under 10 years old and a repair below 50% of a new one, fix it. Over 10 years, if your cumulative repairs across the past two-to-three years top 40% of replacement cost, replacing wins on both cost and a fresh warranty.

Maintenance that heads off these failures#

Stay ahead of the common FFCD2413 (Entry Dishwasher) faults with this short routine:

• Clean the drain filter after every 5-10 loads
• Run hot water at the sink before starting to ensure proper detergent dissolution
• Use rinse aid to improve drying performance with the heating element
• Check spray arm rotation monthly — spin by hand to verify free movement

Making the FFCD2413 (Entry Dishwasher) last#

To keep your dishwasher running efficiently, clean the filter assembly every 1-2 weeks, run an empty hot cycle with dishwasher cleaner or white vinegar monthly, and use rinse aid for better drying results. Load dishes so that nothing blocks the spray arm rotation — the spray arms must spin freely for proper cleaning. Scrape but do not pre-rinse dishes — modern dishwashers need some food residue for the soil sensor to determine the correct cycle intensity.

Related guides#

• Frigidaire Dishwasher Not Draining

Need hands on it? Book a Frigidaire FFCD2413 (Entry Dishwasher) repair — same-day and next-day slots, upfront pricing, and a 90-day parts-and-labor warranty.