Maytag Oven Error Codes — Complete Error Code Diagnosis Guide

Five Maytag oven codes are decoded here, and two of them bracket the self-clean cycle from both ends. F5E1 is a latch that never reaches locked — a stripped gearset, a position switch not making, or a door sprung out of square by heat. F9E0 is the opposite trap, a latch stuck locked after the clean, stalled on its release swing or bound by a hinge. F3E0 is the RTD probe reading open, often a rear plug backed off its pins or a pigtail cooked brittle. F1E0 is a control memory read failure, and F2E0 a shorted keypad.

The latch pair is worked mechanically, because the two failures share a part but not a repair: one is diagnosed with the door open and the mechanism watched through its travel, the other with the oven cool and the hinge checked for bind. F3E0 is proved at the rear connector with a meter rather than by fitting a probe. F1E0 is separated from the keypad code by whether the fault survives a power cycle, since scrambled stored settings and a shorted pad both leave a panel behaving strangely.

A door locked over a cavity that has just finished a clean cycle is the moment to be patient rather than forceful — the latch is already the part reporting a fault, and levering it makes the repair larger. The control board and cavity harness behind the rear panel are at line voltage, and a gas range runs a supply line into the same space. Where a guide marks the step professional-only, that is the boundary. EasyBear services Maytag ovens and ranges across Sacramento and the Bay Area.