Jenn-air Oven Error Codes — Complete Error Code Diagnosis Guide

Nine Jenn-Air oven codes are indexed here, and the door lock takes three of them. F5E1 is a self-clean lock that will not lock, F5E2 is one that will not unlock, and F9E0 is a latch motor stalled partway through its travel on a bent cam or stripped gear. The cavity probe accounts for F3E0 open and F3E2 shorted. F2E0 and F2E1 are the touch panel — a worn membrane against an unseated ribbon. F1E0 is a control board memory read or write failure, and F6E0 is the gas ignition and safety valve circuit.

The lock trio is worked as a mechanical problem before an electrical one, because a door warped by clean-cycle heat and a burned-out latch motor produce the same refusal, and only one of them is cured by a part. The probe pair is settled with a meter at the rear connector rather than by substitution. F2E0 and F2E1 are separated by whether the panel responds at all, since a disconnected ribbon looks like a dead touchpad from the front and costs nothing to reseat.

F6E0 is the entry that sets the boundary for this appliance. A weak igniter can leave the safety valve opening with nothing lighting, which is a gas condition rather than an inconvenience, and igniters, safety valves and their circuits are professional work regardless of confidence. A door locked shut mid-clean also deserves patience rather than force — the latch is the part reporting the fault. EasyBear services Jenn-Air ovens and ranges across Sacramento and the Bay Area.