Want a regional phone & address? Pick your area.
The door cannot unlock.
If the Hot cycle is selected, wait until cool-down and touch and hold the Power button again for at least 3 seconds.
Turn on the washer.
If the Error Code still appears, check and correct the possible cause as indicated for the “Clean filter” error code.
Then turn on the washer again.
Parts That May Need Replacement
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Here's what a professional technician does to resolve this issue:
If the Hot cycle is selected, wait until cool-down and touch and hold the Power button again for at least 3 seconds.
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Don't let error code F29 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends Sep 15
Whirlpool error code F29 indicates: The door cannot unlock.. This is a medium-severity issue affecting your washer.
If the Hot cycle is selected, wait until cool-down and touch and hold the Power button again for at least 3 seconds. Then, Turn on the washer. Then, If the Error Code still appears, check and correct the possible cause as indicated for the “Clean filter” error code. There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
Repair costs for Whirlpool F29 typically range from $100 to $500 depending on the specific cause. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.